Error messagesWarningError No. TV monitor display* Descriptions VTR operationE-00*(Err-00) SERVO NOT LOCKED Error No. lights when servo disturbances continue for 3 ormore seconds during playback, recording or editing. ContinuedE-01*(Err-01) LOW RFError No. lights when envelope levels approx. 1/3 that ofnormal levels are detected for more than 1 sec. duringplayback, recording or editing.Error No. lights when a fan motor stops operating.StopE-10*(Err-10) FAN STOP Stop* Displays when warning information is checked by pressing the DIAG button.AUTO OFF modeThe following error number flashes on the counter display section.Error No. Descriptions VTR operationWhen condensation is detected, the error no. display flashes, and the unit goes intoEJECT mode. The drum rotates after the cassette tape is ejected to removecondensation.When the condensation has been removed, the error no. display disappears and theVTR may be used.E-20E-29E-31E-35E-36E-37E-51The message display flashes when the take-up reel has been rotating idly for a fixedperiod of time while the start/end processing operation during loading (half position) isbeing performed.E-52E-53E-551) The drum rotates as soon as condensation is detected when the unit is in EJECTmode.2) When condensation is detected while a cassette tape is inserted, drum rotation stops,the cassette tape is ejected and the drum rotation begins again.EJECTThe cassette does not move up even when 6 seconds have elapsed since the VTR wastransferred to the eject mode. StopThe unloading operation is not completed within 10 seconds.StopThere is no response from the servo microcomputer for 1 or more seconds.StopOnly the servo microcomputer was reset in an instantaneous power failure.StopThe servo microcomputer does not follow the instructions of the system controlmicrocomputer even when 10 seconds have elapsed. StopStopAfter the cassette has been inserted, the tape take-up reel has not wound up the tapewhile the total tape amount is not detected and while the tape is traveling at or abovethe normal tape speed in the forward or reverse direction.StopAfter the total tape amount has been detected, the amount of tape wound up on thetake-up reel and the amount of tape supplied by the supply reel differ to an abnormalextent while the tape is traveling.StopThe tape has not been wound up during unloading.Stop– 4 7 –