Controls and their functions (continued)ANALOG COMPONENT VIDEO OUT connectorThe analog component video signal is output from this connector.ANALOG COMPOSITE VIDEO OUT connectorsThe analog composite video signals are output from these connectors.The video signal with signals superimposed on it can be output from the VIDEO OUT3connector.The superimpose function can be set ON or OFF on the setup menu No. 006 (SUPER).DIGITAL AUDIO IN/OUT connectorThis I/O connector is for digital audio signals which comply with the AES/EBU standard.SERIAL DIGITAL COMPONENT AUDIO/VIDEO IN/OUT connector(optional AJ-YA750P interface board required)This I/O connector is for digital component audio and video signals which comply with theSMPTE 259M-C/272M standard.Remote control connectorsThe unit can be controlled from an external source by connecting the unit with anotherunit or an external controller.There are two remote control connectors, one for IN/OUT uses and the other for OUTuses.IN/OUT: For connection with an external controller.For connection with deck-to-deck operation.OUT: For connection with parallel running operations.For use in a loop-through configuration.ENCODER REMOTE connectorThe external encoder/controller is hooked up to this connector when the video outputsignal and other settings are to be adjusted from an external source.RS-232C connectorPARALLEL REMOTE connectorThis is used when operating the unit from an external source.- 1 8 -
