Panasonic AJ-D750P Operating Instructions Manual

Contents

Connector signalsPARALLEL REMOTE (25P)Pin No. Signal Pin No. Signal1 PLAY COMMAND 102 STOP COMMAND 113 FF COMMAND 12 > 10V, MAX 300mA4 REW COMMAND 13 PLAY STATUS5 REC COMMAND 14 STOP STATUS6 EJECT COMMAND 15 FF STATUS7 STANDBYON/OFFCOMMAND 16 REW STATUS8 PREROLL COMMAND 17 REC STATUS9 IN SET COMMAND 18 EJECT STATUSPin No. Signal19 STAND BY ON STATUS20 PREROLL STATUS21 SERVO LOCK STATUS22232425 GNDCOMMAND pins: TTL level, active low, 100ms edge electrical signal.STATUS pins: open collector, sink current 6mARS-232C REMOTE (25-pin D-SUB crossover cable supported)Pin No. Abbreviation Circuit Description1 FRAME GROUND Protective ground Frame ground2 RxD Received data Sends data to the PC.3 TxD Transmitted data Receives data from the PC.4 CTS Clear to send Shorted with pin 5.5 RTS Request to send Shorted with pin 4.6 DTR Data terminal ready No processing7 GND Signal ground Signal ground20 DSR Data set ready Positive power output after communication enablestatusExample of connections with controller (PC) using a 25-pin D-SUB crossover cablePC end (D-SUB 25 pins) VTR end (D-SUB 25 pins)FG 1TxD 2RxD 3RTS 4CTS 5DSR 6GND 7DTR 201 FG2 RxD3 TxD4 CTS5 RTS6 DTR7 GND20 DSRENCODER REMOTE (15P)Pin No. Signal Pin No. Signal Pin No. Signal1 6 SYSTEM H 0 11 RET GND2 SET UP 7 SYS.SC COARSE (2) 123 C LEVEL 8 –12V 134 GND 9 HUE 14 SYS.SC FINE5 +12V 10 VIDEO LEVEL 15 SYS.SC COARSE (1)- 68 ->=

/ 71

Related manuals for Panasonic AJ-D750P