Panasonic AJ-D910WB Operating Instructions Manual

Contents

Panasonic AJ-D910WB Operating Instructions Manual Manual pdf 156 page image

– 156 (E) –CONTENTSInspections Before ShootingInspecting the Iris and Zoom Functions1 Set the zoom to electric zoom mode and check the electric zoom operation. Check that theimage changes to telephoto and wide angle.2 Set the zoom to manual zoom mode and check the manual zoom operation. Turn the man-ual zoom lever and check that the image changes to telephoto and wide angle.3 Set the iris to automatic adjustment mode and aim the lens at subjects with differing bright-ness to check that the automatic iris adjustment functions.4 Set the iris to manual adjustment mode and turn the iris ring to check the manual iris adjust-ment.5 Hold down the instant iris automatic adjustment button and aim the lens at subjects withdiffering brightness to check the instant iris automatic adjustment performance.6 Return the iris to automatic adjustment mode and change the GAIN switch setting to L, Mand H to check the following items.ÁThe iris is adjusted with respect to subjects with the same brightness in accordance withthe switch setting.ÁThe gain value display on the viewfinder screen changes in accordance with the switchsetting.7 When a lens with an extender is mounted, set the extender to the used position to checkthat the extender functions properly.Perform “(1) Tape Running Inspections” to “(4) Earphone and Speaker Inspections” below consecutively.Inspecting the VTR Section(1) Tape Running Inspections1 Set the VTR SAVE/STBY switch to SAVE and check that the VTR SAVE lamp inside theviewfinder lights.2 Set the VTR SAVE/STBY switch to STBY and check that the VTR SAVE lamp goes off.3 Set the F-RUN/R-RUN switch to R-RUN.4 Set the DISPLAY switch to CTL.5 Press the unit’s VTR START button and check the following items.ÁThe tape reels turn.ÁThe counter display number changes.ÁThe REC lamp inside the viewfinder lights.ÁThe RF and SERVO lamps in the display window do not light.6 Press the unit’s VTR START button again. Check that the tape stops and the REC lampinside the viewfinder goes off.7 Check the same operations as in steps 5 and 6 using the VTR button of the lens.8 Press the RESET button and check that the counter display number changes to“00:00:00:00”.9 Set the LIGHT switch to ON and check that the display window is illuminated.10 Press the REW button to rewind the tape for a few moments, and then press the PLAY/PAUSE button. Check that the recording, playback and rewind operations are performedproperly.11 Press the FF button and check that fast forward operation is performed properly.