Panasonic AJ-HD2000 Operating Instructions Manual

Also see for U-20ME1E81: Installation instructions Service manual Service manual Operating instructions Installation instructions

Contents

Panasonic AJ-HD2000 Operating Instructions Manual Manual pdf 123 page image

– 123 –INTERFACE SET UP menuKeyF1F2F3F4F5F6Key designationP-2RS-422A Control modesetting.RS-232CPARA50P parallel remoteON/OFF.AV CONT.V/A control.FF/REW MAX SPFF/REW maximum speedsetting.DEV. IDDevice type.DescriptionWhen the component connected to the RS-422A REMOTEconnector is to be operated by remote control, one of four modescan be selected to match the system configuration. The flow ofthe signals in each mode is displayed on the menu. (Refer to“Correlation between modes and connectors” (on page 125).)MODE-1: The VTR connected to the REMOTE OUT orREMOTE IN/OUT connector is controlled.MODE-2: Two or more VTRs are controlled in the same modeas this unit.MODE-3: The VTR connected to the REMOTE OUT connectorcan be controlled.MODE-4: Two or more VTRs can be controlled in the samemode as this unit.OFF: No control is exercised using RS-422A.ON: Enables parameter settings and control.OFF: Disables parameter settings and control.BAUD RATE: Baud rate settings. The following baud ratescan be set: 300, 600, 1200, 2400, 4800, and9600.DATA LENGTH: Data length setting. Data lengths 7 and 8 canbe set.START BIT: Start bit setting. Start bit 1 (fixed).STOP BIT: Stop bit setting. Start bits 1 and 2 can be set.PARITY: Parity bit setting. Parity bits are NON, ODDand EVEN.ON: Enables control.OFF: Disables control.ON: Enables control from the V/A controller.OFF: Disables control from the V/A controller.The AV control parameter is fixed at the baud rate of 1200 bps.Tape speed at FF or REW can be set at k50 or k32.50: Maximum tape speed at FF/REW can be set at n50 times.32: Maximum tape speed at FF/REW can be set at n32 times.Can be set by pressing the C, F and F6 keys simultaneously.Enables selection of the device ID returned to controller viaRS-422A.There are 6 types of device ID: DEFAULT1, DEFAULT2, ID-1,ID-2, ID-3 and USER. Select ID to match the controller in use.To change the USER setting device ID, consult with servicepersonnel.DEFAULT1: “F†130” is returned. (e.g. “F030” will be returned whenthe system frequency is 59 Hz.)DEFAULT2: “F†24C” is returned.ID-1: “4†103” is returned.ID-2: “0†120” is returned.ID-3: “F†119” is returned.USER: “Optional user setting” is returned.°1When the system frequency is 50 Hz or 25 Hz, “1” will replace the asterisk and “0” will replace it for all otherfrequencies.°2When the system frequency is 23 Hz or 24 Hz, “2” will replace the asterisk, “1” will replace when it is 50 Hz or25 Hz, and “0” will replace the asterisk for all other frequencies. However, even though the system frequencyis 23 Hz, “0” will replace when the 30TC is selected as the RC_TC setting. (See page 86.)