23Display PanelParameter ListUSER SETSetting item Setting RemarksDropped Frame DFNDFSelects the frame mode in use.Protocol OdeticsLouthSelects the control protocol in use withRS-422A.FF.REW Max x32, x64,x128Selects the speed for FF/REW.SDTI Slow Audio ValidInvalidSelects audio data output for playbackat a1 speed or below.Rec StartPosition00:00:0000:59:5901:00:00Selects the recording starting pointwhen recording instruction has beengiven by operating the front panelwhen creating a new CLIP.Record Duration 10min15min30min45min1H2H4H8HSelects the recording time length ofCLIP ID used during loop recording (L-REC).OUpon writing over the existing CLIPID, loop recording takes place withinthe length of recording time set fromthe current position.OLoop recording operation takesplace only during STOP.FTP Put Offset 00:00:0000:59:5901:00:00Selects the recording starting pointwhen recording is done throughtransmission from a non-linear system.SDTI Illegal Input Rec StopContinueSelects operation when SDTI signalhas detected no signal duringrecording.Ch1 Default Rate 25Mbps50Mbps100MbpsSelects the format of signals used ineach channel.However, the upper limit of maximumusable stream count (25 Mbps modetaken as 1) that has been set cannotbe exceeded.For details, consult your dealer.Ch2 Default Rate 25Mbps50Mbps100MbpsCh3 Default Rate 25Mbps50Mbps100MbpsCh4 Default Rate 25Mbps50Mbps100MbpsCh1 DefaultTimesx1, x2, x4Ch2 DefaultTimesx1, x2, x4Ch3 DefaultTimesx1, x2, x4Ch4 DefaultTimesx1, x2, x4A/S SETSetting item Setting RemarksCH1 CF Enable OnOffSelects channel 1 color frame control.CH1 VOUTSetUpAddThruSelects setup level during channel 1playback.CH1 VIN SetUp CutThruSelects setup level during channel 1recording.CH1 SYS H –1210 +120Performs rough tuning of channel 1system phase in relation to standardsignal. (37ns step)CH1 SYS SC 0 1023 Performs fine tuning of channel 1system phase in relation to standardsignal. (0.35° step)CH1 SCH –1280 +127Performs tuning of channel 1 SC-H(Subcarrier to Horizontal) phase.(1.41° step)CH2 CF Enable OnOffChannel 2 setting is the same as forchannel 1.CH2 VOUTSetUpAddThruCH2 VIN SetUp CutThruCH2 SYSH –121 0+120CH2 SYS SC 0 1023CH2 SCH –128 0+127CH3 CF Enable OnOffChannel 3 setting is the same as forchannel 1.CH3 VOUTSetUpAddThruCH3 VIN SetUp CutThruCH3 SYSH –121 0+120CH3 SYS SC 0 1023CH3 SCH –128 0+127CH4 CF Enable OnOffChannel 4 setting is the same as forchannel 1.CH4 VOUTSetUpAddThruCH4 VIN SetUp CutThruCH4 SYSH –121 0+120CH4 SYS SC 0 1023CH4 SCH –128 0+127indicates factory setting mode.
