Panasonic AJ-RC5 Operating Instructions Manual

Contents

E-12ENGLISHScene File OperationsIn the scene mode established upon completion of the scene data saving or loading operations,the KNEE SLOPE, KNEE POINT, DETAIL, GAMMA and M.PED VR control operations differslightly from their regular operations.Regular operations: The control positions are sent to the camera recorder as menu datainformation.Operations in scene mode: The data and control positions immediately after scene data savingor loading serve as the reference for operation. In the case of thecontrol data, the changes from the data immediately after saving orloading are sent to the camera recorder.≥ Depending on the positions of the controls during saving and loading, the lower or upper limits of thedata variable ranges may be exceeded by the control variable ranges. In this case, when a particularcontrol is operated after saving or loading, its data will be changed as normal up to the lower orupper limit, but the data will not change any further once the limit is exceeded. Furthermore, when aparticular control is stopped at the position where the lower or upper limit is exceeded, this stoppedposition will serve as the position that indicates the lower or upper limit value.≥ While the scene mode is established, the VTR operations can be performed by setting theVTR/SCENE enable switch to REC ONLY or VTR ON just as with regular operations.Operation mode established by scene file data Releasing the scene modeTo release the scene mode, proceed as follows.As soon as the regular operation mode hasbeen restored from the scene mode, the KNEEPOINT, KNEE SLOPE, DETAIL, GAMMA andM.PED VR control item data changes to thecontrol position data which was established atthat point when the scene mode was released.Furthermore, the data established during thescene mode is used as is for all data with theexception of the control data.Example: Scene No.2 while the scene mode isestablished1 Press the LOAD button.All the button LEDs now go off.≥ The scene mode is automatically releasedwhen the power of the camera recorder andHEAD POWER switch on the base station areturned off.≥ The scene is also automatically releasedwhen the saving operation has failed andthere is no data to be loaded.START/STOPFFREWS1 S2 SAVEPLAY REC CHKSTOPS3 S4 LOADSTART/STOPFFREWS1 S2 SAVEPLAY REC CHKSTOPS3 S4 LOADThe selected scene No. button and LOADbutton are on.