Panasonic AK-HC1800G Operating Instructions Manual

Also see for AK-HC1800G: Parts list Operating instruction

- 8 (E) -ENGLISH Camera mounting hole (1/4-20UNC) Camera mounting hole (3/8-16UNC)The screw holes can be used to secure the camera for installing it on camera housing,and when using a pan/tilt head or a tripod. The screw holes are 10 mm deep. Usescrews which are less than 10 mm long. MENU switch [MENU]A menu will appear on the monitor screen when MENU switch is pressed for at least seconds. The menu screen is cleared when the switch is pressed for at least secondswhile the menu is displayed. ENTER/AWB switch [ENTER/AWB]The item just below can be selected by pressing this switch while the menu is on thescreen.When the menu is not displayed or the camera is in shooting mode, the automatic whitebalance control (AWB) can be set with this switch. UP/ABB switch [UP/ABB]The item just above can be selected by pressing this switch while the Main menu isdisplayed.While the Sub menu is displayed, any setting can be brought up to a higher value withthis switch.When the menu is not displayed or the camera is in shooting mode, the automatic blackbalance control (ABB) can be set with this switch. DOWN/BAR switch [DOWN/BAR]The item just below can be selected by pressing this switch while the Main menu is onthe screen.While the Sub menu is displayed, any setting can be brought down to a lower value withthis switch.When the menu is not displayed, the color bar and the shooting conditions arealternately indicated by pressing the switch for about 5 seconds.Format conversion using the rear panel switchesWhen there is no menu display, the video output format is switched to“1080/59.94i” or “1080/50i” if the MENU switch  or ENTER/AWB switch  ispressed, respectively, while the UP/ABB switch  and DOWN/BAR switch  areheld down.Major operating controls and their functions