Panasonic AKHC3500 - MULTI FORMAT CAMERA Operating Instructions Manual

Also see for AK-HC3500P: Operating instructions

8Controls and their functions Lens mount (Bayonet type)This is where the lens is mounted. Lens clamp leverThe lens is inserted into the lens mount , and this leveris then turned to clamp the lens in place. Lens cable, mic cable clampsThese are used to clamp the lens cable and mic cable inplace.D Camera hangers (supplied)When the buildup unit (AK-HBU3500) is used, installthese hangers to the camera with supplied screws(M3  8 mm).For details, refer to the Operating Instructions forAK-HBU3500.E Tripod mountBefore securing the Multi-Format Camera to a tripod,attach the tripod adapter (SHAN-TM700) which isavailable as an optional accessory.F Shoulder padThis is used when the Multi-Format Camera is to becarried on the shoulder.G Slide lock release leverThis is held down while it is used to adjust the front/backposition of the shoulder pad F.H Shoulder strap fittingThis enables the shoulder belt to be attached.I Optical cable clampThis enables the optical cable to be clamped.J Camera No. plate holderThis enables the accessory camera No. plate to beattached.K Optical fiber connector(EDW.3K made by LEMO) Camera power switch [POWER]This is used to select the camera power input (powersupplied from the CCU or from an external connector)and turn the power ON and OFF. Power LEDThis lights up green when power is supplied to thecamera.When the camera’s power switch is set to OFF, this lightsup red if the CCU is connected, and it goes off if the CCUis not connected. Power circuit breaker [BREAKER]This shuts off the power in the event of an overcurrentwhile the DC 1 V power supply is used.To reset it, press the circuit breaker button. INCOM connectors 1, 2 [INCOM1, INCOM2]The INCOM or headset plugs are connected here. INCOM1 MIC ON/OFF switch [MIC1 TALK]This is the INCOM1 MIC ON/OFF selector switch. INCOM1 level control [INCOM1 LEVEL]This is used to adjust the INCOM1 receive level. INCOM2 MIC ON/OFF switch [MIC2 TALK]This is the INCOM MIC ON/OFF selector switch. INCOM2 level control [INCOM2 LEVEL]This is used to adjust the INCOM receive level.9 INCOM1 PGM1 level control [INCOM1 PGM1]This is used to adjust the INCOM1 and PGM1 mixinglevel. INCOM1 PGM2 level control [INCOM1 PGM2]This is used to adjust the INCOM1 and PGM mixinglevel. INCOM2 PGM1 level control [INCOM2 PGM1]This is used to adjust the INCOM and PGM1 mixinglevel. INCOM2 PGM2 level control [INCOM2 PGM2]This is used to adjust the INCOM and PGM mixinglevel. RET-A selector switch [RET A]This switch is used to select the return images to beswitched by RET-A. RET-B selector switch [RET B]This switch is used to select the return images to beswitched by RET-B. CALL LEDThis lights up green when the CALL switch is pressed.It also lights in response to a call from the ROP or MSU. CALL switch [CALL]This lights the CALL LED on the ROP or MSU andsounds the buzzer. OPT LEDThis indicates the camera’s optical signal receptionstatus. It normally lights up green. When any problem hasoccurred, it lights up red.When a problem has occurred, clean the optical fiberconnector.