Panasonic AW-HE130WP Operating Instructions Manual

Also see for AW-HE130KE: Operating instructions Installation instructions Operating instructions

Contents

Panasonic AW-HE130WP Operating Instructions Manual Manual pdf 38 page image

This unit can be operated by remote control using a wirelessremote control (model number: AW-RM50G) purchased separately.Check out the following points before using the wireless remotecontrol.z Point the wireless remote control at the unit’s wirelessremote control signal light-sensing area (front panel orback panel), and operate it within a range of 10 meters(32.8 ft) from these areas.z Refer to “Layout of wireless remote control signallight-sensing areas” on the right.z The signal sensing distance is reduced if the angle atwhich the wireless remote control signals are sensed isincreased.The light-sensing sensitivity is reduced to about one-half when thewireless remote control is pointed at an angle of 40 degrees fromeach position in front of a wireless remote control signal light-sensingarea (front panel or back panel).If the remote control is operated from the behind the unit, it may beeither difficult or impossible to perform the desired operations.z If the unit is installed near fluorescent lights, plasmamonitors or other such products or if the unit isexposed to sunlight, the effects of the light may make itimpossible for the unit to be operated using the wirelessremote control.Be sure to follow the steps below for installation and use.• Take steps to ensure that the wireless remote control signal light-sensing area will not be exposed to the light from fluorescent lights,plasma monitors or other such products or from the sun.• Install the unit away from fluorescent lights, plasma monitors andother such products.z For about 10 minutes even after the batteries have beenremoved from the wireless remote control, the selectionof the operation to be performed (the , , or button which was pressed last) willremain stored in the memory.When a longer period of time elapses, however, theselection is reset to the status established when the button was pressed. of wireless remote control signal light-sensing areas>• The arrows in the figure below show the light-sensing directions inwhich the wireless remote control signals travel.Approx. 45°Approx. 45°Wireless remote controlsignal light-sensing area(back panel, 1 place)Wireless remotecontrol signal light-sensing area (frontpanel, 2 places)Approx. 45°Approx. 45°• Top view• Rear panel viewWireless remote control (optional accessory)38