Panasonic BL-C10 Installation & Troubleshooting Manual

Also see for BL-C10: Operating instructions Installation & configuration guide Getting started

Contents

Installation/Troubleshooting71.2 Camera Feature Locations1.2.1 Front ViewPrivacy ButtonTo temporarily deactivate the camera, press the privacy button. Once pressed, thebutton changes from green to red. The video will be temporarily turned off, camerafeatures become unresponsive and the viewed image turns to a gray screen. Toreturn to normal operation, press the privacy button again. It should turn greenwithin a few seconds. To restore video, click [Refresh] on the web browser. Privacymode can also be controlled from mobile phones or PCs (see page 25 or page 73of the Operating Instructions in the Setup CD-ROM).Indicator DisplayPan/Tilt PartDo not apply pressure to the pan/tilt portion of thecamera. Any forced movement can damage the internalmechanism.Indicator/Privacy ButtonPyroelectric Infrared Sensor (see Getting Started)PoweronNormal Operation*1*1 The indicator turns orange if the camera is not connected to the LAN.*2 The indicator blinks orange if the camera is not connected to the LAN.Updating FirmwareGetting IP address*2Got IP addressSettingFinished settingNot on the LAN Orange Orange blinkingOrange blinking(The camera restarts about 1 minute later.)Pressing FACTORYDEFAULT RESET buttonOrange blinking Turning offUPnPTM Failure*3 Orange blinking (About a 2-second interval)On the LANUsingDHCPAutomaticSetupIn Privacy Mode RedInternal Failure Red blinkingOrange GreenGreenGreenGreenOrange and green blinkingGreen blinkingGreen blinking*3 When the sensor is active, the interval between blinks may increase.Orange blinking