Panasonic BL-C10E Installation & Configuration Manual

Also see for BL-C10: Operating instructions Getting started Installation & troubleshooting guide

Contents

Panasonic BL-C10E Installation & Configuration Manual Manual pdf 3 page image

Panasonic BL-C10 Camera Installation & Configuration Guide 3This guide explains how to install and configure Panasonic BL-C10 camera in the localnetwork.It is strongly recommended that you add only one camera at a time to the network forconfiguration.1 PrerequisitesBefore the configuration check the following: The camera is unpacked and correctly connected to the power source and network. The LED indicator on the camera front side should glow green and not flashing.The first boot cycle of a Panasonic BL-C10 camera takes about 1 minute. During thebooting process the LED indicator will be flashing. Wait until it stops flashing andbegins to glow green. If the LED color is orange, recheck the network cableconnection. (see Appendix A p.8) WebCCTV NVR is installed, activated, running and properly connected to the network(see Installation manual). You have an exact list of IP addresses and passwords for WebCCTV NVR and networkcameras. The IP address of WebCCTV NVR is properly configured (see Installation manual). Panasonic Network Camera installation CD is available. Monitor, keyboard and mouse are connected to WebCCTV NVR (see Installationmanual).You can use another PC or laptop providing they are in the same local network. Makesure that it has an IP address in the same range as the WebCCTV NVR and thecamera.Version 3.0 Series