Panasonic BT-LH1850 Operating Instructions Manual

Also see for BT-LH1850: Brochure

30Main menu (continued)*1 The settings are cancelled when the power is turned OFF.*2 If these settings are changed, the menu settings will also change.*3 The control settings do not operate during GPI operation.*4 Not displayed when “16:9”, “4:3” and “CENTER” are all “OFF” in the MARKER menu settings.RESET operation1. Turn the rotary knob in the “SYSTEM CONFIG” menu toselect the “CALIBRATION” submenu and press the rotaryknob.2. Turn the rotary knob to select the “RESET” submenu andpress the rotary knob.MENU EXIT RETURN RETURNSEL. ENTER[RESET]YESNO3. Select “YES” and press the rotary knob.This starts calibration.MENU EXIT RETURN RETURNSEL. ENTER[RESET]xxxxxxxxxxxxxxxxxx indicates that the following message with the mean-ing listed below appears.COMPLETE: Operation completed4. Turn the power off and then on after performing reset op-eration.FUNCTIONThe underlined values are factory preset setting values.Sub menu Settings DescriptionFUNCTION 1 -FUNCTION 5HV DELAYBLUE ONLYGAMMA SELECTSD ASPECTSCANSUB WINDOWWFM/VECTORMARKERWHITE BALANCEPIXEL TO PIXELPIXEL POSITIONFOCUS-IN-REDLEVEL METERCROSS HATCHMONOBLACK MODETIME CODECLOSED CAPTIONAUDIO MUTEUNDEF(Factory defaultsFUNCTION1:MARKERFUNCTION2: WFM/VECTORFUNCTION3: PIXELTO PIXELFUNCTION4: TIMECODEFUNCTION5: LEVELMETER)Selects functions to be assigned to [FUNCTION1] - [FUNCTION5] (front panelbuttons) or the FUNCTION menu. *1Displays the image blanking period.The display changes in the following order.DELAY OFF → H DELAY → V DELAY → HV DELAY → DELAY OFF *1Cuts the red and green signals. Use this function to check phase and chroma. Thisbutton toggles between ON and OFF.*2*3Selects the gamma curve.The display changes in the following order.GAMMA STANDARD → GAMMA FILM → GAMMA STDIO/PST →GAMMA STANDARD *2*3Switches between “16:9” and “4:3.” *2*3Switches between “UNDER SCAN” and “NORMAL SCAN”. *1Sets the split-screen function.The display changes in the following order.SINGLE → FULL/PART → STILL → SINGLE *2Displays waveform or vector display.For details on the available operation items, refer to page 33. *2*3*4Turns the marker on and off.For details on the available operation items, refer to page 33.WHITE BALANCE GAIN/BIAS RGB direct adjustment can only be accessed whenVAR1 to VAR3 are selected in COLOR TEMP.Turns the PIXEL TO PIXEL function On and Off.Positions the display of signals in PIXEL TO PIXEL mode.