Panasonic BT-LH2600W Operating Instructions Manual

Also see for BT-LH2600WE: Mechanical Parts List

Panasonic BT-LH2600W Operating Instructions Manual Manual pdf 10 page image

10SDI (HD/SD) terminal (BNC)IN1 : This is the SDI input terminal (compatible with HD/SD automatic switching).IN2 : This is the SDI input terminal (compatible with HD/SD automatic switching).SWITCHED OUT : This is the active through-out terminal for the SDI input signal being displayed on the screen.* SDI active through-outSignal output results only when [SDI1] or [SDI2] is selected in [INPUT SELECT]. No output results when theselected input is not SDI.The terminal is compatible with embedded audio.Outputting signals received through the SDI input terminals and converted to analog is not possible.VIDEO terminal (BNC)*1*2IN : This is the VIDEO signal (composite signal) input terminal.OUT : This is the composite input signal through-out terminal.Y/C terminal*1*2IN : This is the Y/C signal (S-video signal) input terminal.OUT : This is the Y/C input signal through-out terminal.* Wide display (16:9) information from the input signal is not automatically detected.Change the aspect ratio settings, referring to SD ASPECT (J page 19) on the VIDEO CONFIG Menu.YP BP R/RGB terminal (BNC)*1*2IN : This is the YP B P R/RGB signal input terminal.OUT : This is the YPB P R/RGB input signal through-out terminal.* When using the RGB signal, you can also connect the external synchronizing signal to the SYNC/HDterminal. When using a PC RGB signal, connect the horizontal synchronizing signal to the SYNC/HDterminal, and the vertical synchronizing signal to the VD terminal.VD IN input terminalThis is the vertical synchronizing signal (VD) input terminal used when connecting to a PC RGB signal.AUDIO input terminal (Pin terminal)This is the common audio input terminal for all video input terminals.* When an embedded audio unit BT-YAE1700G (optional) is attached, SDI input audio is automaticallyselected by selecting [SDI1] or [SDI2] with [INPUT SELECT].GPI input terminal (D-SUB 9-pin)External control is possible by using a GPI signal.RS-232C input terminal (D-SUB 9-pin)External control is possible by using a RS-232C signal.*1 When a cable is not connected to the through-out terminal, the VIDEO IN terminal automatically bears 75 Ωresistance. When the cable is connected, 75 Ω resistance is removed.*2 When the through-out terminal is used, depending on connected equipment, the unit's picture level may beexceeded because 75 Ω resistance at the end of the terminal is automatically removed.Rear panel6 7 81 2 3 4 5Controls and Their Functions (continued)