9Security MeasuresSetting the User Password (enabling, changing, disabling)1 Run the Setup Utility ( page 28)2 Using either or , select [Security]3 Using either or , select [Set User Password] and pressEnter4 Enter your password at [Enter Current Password] and pressEnter5 Enter your password at [Enter New Password] and pressEnterTo disable the User PasswordPress only Enter6 Re-enter your password at [Confirm New Password] and pressEnterTo disable the User PasswordPress only Enter7 At [Setup Notice], press Enter8 Press F10 and select [Yes], then press EnterWhen the Supervisor Password has not been set, the User Password can not beset. Set the Supervisor Password if you have not done so. ( page 8)NOTEDo not forget your password. If a password is forgotten, you will be unable to useyour computer. If this happens, log on with the Supervisor Password, or ask aperson who knows the Supervisor Password.When running the Setup Utility, do not leave your computer even for a short time,as the possibility exists for the password to be set/changed by another person.CAUTIONYour password will not be displayed on the screen.Only up to seven alphanumeric characters can be used.• There is no distinction between upper and lower case letters.• Use only the upper horizontal row of numeric keys to input your password.• Do not input your password while holding down Shift or Ctrl .When you do not want the User Password enabled or changed withoutpermission:1 Run the Setup Utility and enter the Supervisor Password.2 Using and , select [User Password Protection] in [Security] menu andpress Enter .3 Using and , select [Protected] and press Enter .NOTE
