11 Read Me First This equipment is provided with external antenna connector(s) for connection to optional Car Mounter or Port Replicator formobile external mounted antenna(s). External antenna(s) must be professionally installed and cannot exceed recommendedmaximum antenna gain as described in individual provided supplement instructions for wireless transmitters.For WLAN, the Car Mounter should be used with Radiall/Larsen WLAN whip antenna, type NMO5E2400BKTNC with 5dBi an-tenna gain or less. Also, user must maintain minimum 20 cm spacing between external antenna(s) and all person’s body (ex-cluding extremities of hands, wrist and feet) during wireless modes of operation.25-M-1This product is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range. FCC requires this product to beused indoors for the frequency range 5.15 to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile Satel-lite systems. High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radarstations can cause interference with and/or damage this product.25-M-WResponsible Party: Panasonic Corporation of North AmericaTwo Riverfront PlazaNewark, NJ 07102Tel No:1-800-LAPTOP5 (1-800-527-8675)Support Contact: http://www.panasonic.com/contactinfo6-M-1FCC Regulation Notice for modemThis equipment contains a FCC approved modem.1. This equipment complies with CFR47 Part 68 rules.On the computer is a label that contains, among other information, the FCC registration number and ringer equivalence number(REN) for this equipment. If required, this information must be provided to the telephone company.2. An FCC compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be con-nected to the telephone network or premises wiring using a compatible modular jack which is Part 68 compliant. See InstallationInstructions for details.3. The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on thetelephone line may result in the devices not ringing in response to an incoming call. In most, but not all area, the sum of RENsshould not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the totalRENs, contact the local telephone company.4. If your telephone equipment cause harm to the telephone network, the telephone company will notify you in advice that tempo-rary discontinuance of service may be required. But if advice notice isn’t practical, the telephone company will notify the custom-er as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.5. The telephone company may take changes in its facilities, equipment, operations or procedures that could affect the operation ofthe equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifica-tions to maintain uninterrupted service.6. If trouble is experienced with this equipment, for repair or warranty information, please contact Panasonic Corporation of NorthAmerica at DIAL TOLL FREE 1-800-LAPTOP5 (1-800-527-8675). If the equipment is causing harm to the telephone network,the telephone company may request that you disconnect the equipment until the problem is resolved.7. There are no user serviceable parts contained in this equipment.8. This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject tostate tariffs.9. The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic deviceto send any message via a telephone fax machine unless such message clearly contains in a margin at the top or bottom ofeach transmitted page or on the first page of the transmission, the date and time it is sent and an identification of the businessor other entry, or other individual sending the message and the telephone number of the sending machine or such business,other entity, or individual. In order to program this information into your fax software, you should refer to the manual of the Faxsoftware being used.10. According to the FCC’s electrical safety advisory, we recommend that you may install an AC surge arrestor in the AC outlet towhich this equipment is connected. Telephone companies report that electrical surges, typically lightning transients, are verydestructive to customer terminal equipment connected to AC power sources and that this is a major nationwide problem.“Caution : To reduce the risk of fire, use only No.26 AWG or larger (e.g., 24 AWG) UL listed or CSA certified telecommunicationline cord.”“ATTENTION : Pour réduire le risque d’incendie, utiliser uniquement des conducteurs de télécommunications 26 AWG ou desection supérieure (p.ex. 24 AWG) UL énumérés ou CSA certifié.”16-M-1UL1604-conforming model. (The model which has description of “UL1604” in the bottom of the computer.)THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I, DIVISION2, GROUPS A, B, C, AND D OR NON-HAZARDOUS LOCA-TIONS ONLY.WARNING-EXPLOSION HAZARD-SUBSTITUTION OF COMPONENTS MAY IMPAIR SUITABILITY FOR CLASSI, DIVISION2.When connecting and using a device manufactured by a third party, enquire to the manufacturer as to whether the device suitsCLASS1, DIVISION2.33-M-1-1
