Panasonic CF-25 Operation Instructions Manual

Also see for CF-25: Operating instructions Operating instructions Operating instructions Operating instructions

3 0Dealing with ProblemsWhen a problem occurs, please refer to this page. If you think it has to do with the software application you are using, pleaseread the related manual. If for some reason you still cannot figure out the problem, please consult your nearest Panasonic dealer.Starting UpThe power indicator or bat-tery indicator is not litis displayedis not displayed(Once this icon is executed, it willnot be displayed later)is not displayed[POST Start Up Error(s)] isdisplayedThe pre-memory count,Windows startup, or an op-eration is extremely slowThe date and time areincorrectCheck the cable connection for the AC adapter. page 6Check to see if a fully charged battery is properly installed. page 14Pressing the reset button will solve the problem. page 42Please input your password. If you have forgotten it, consult your nearest Panasonic dealer.If before you double-click it disappears, select [Start]-[Run], input[c:\util\avapp\psetup.bat], and press .Select [Start]-[Run], input [c:\util\avapp\manual\seticon.bat], and press .page 29Run [Load Default Settings (PnP)] in the Setup Utility. This will restore the Setup Utility'ssettings to their default values (except the password settings). Then, the Setup Utility must berun once again for you to input the appropriate operating environment settings. (The processingspeed depends on the application software used, so this operation may not cause the processingspeed to increase.)You can set the date and time through [Date/Time] in [Start] - [Settings] - [Control Panel].Another way is with the DATE and TIME commands in MS-DOS.If you continue to experience problems, the internal battery maintaining the clock mayneed to be replaced. Please consult your nearest Panasonic dealer.The red battery indicatorlights.Repeated beeps sound whilethe computer is in use.The red battery indicatorlights, a beep soundsThe red indicator blinksThe red indicator lights (ora 99% reading is displayed) foran extended period of timeAfter the AC adapter is con-nected, the orange indicatorblinks five timesThe battery level is low. Connect the AC adapter or replace the battery pack with a fullycharged one. If you have neither the adapter nor an extra battery, save your data and poweroff your computer.The battery temperature has risen due to electrical discharge caused by a large load. Connectthe AC adapter, set the power-saving function, and turn down the brightness of the display toreduce the load on the battery.The battery pack or recharging function may be defective. Quickly remove the batterypack and disconnect the AC adapter, then connect them again.If the problem persists, consult your nearest Panasonic dealer.When the battery pack is fully charged, turn on your computer, unplug the AC adapter, thencompletely discharge the battery.Unable to charge because of an improper temperature range. page 15Battery IndicatorCharacter InputUnable to input anythingbut numeralsOnly capital letters arebeing inputHow to input Europeancharacters (ß, à, ç) orsymbols is unclearIf NumLk and Key Pad are on, the Numeric Key Pad is ON. To switch it OFF,press + .If CapsLock is on, the Caps Lock is ON. To switch it OFF, press .Select [Start] - [Run], input [c:\windows\charmap.exe] and press . The CharacterMap will be displayed. Point to the desired font name and select it.