66Port ReplicatorA port replicator is available as an option (CF-VEB272A). This device eliminates the hasslesof having you connect/disconnect the various cables when carrying your computer aroundand allows a variety of peripherals to be connected including a headphone or microphone,etc.The port replicator connects to the expansion bus connector(A) on the back of yourcomputer.For more detailed information, refer to the Operating Instructions of the port replicator.CAUTIONz Hot/Warm Docking and Hot/Warm Undocking are not possible with the port replicator.z When connecting the external display to the display port on the port replicator, thecharacters on the external display may be blurred if 1280 x 1024 (or a higherresolution) is set. In this case, select a resolution that is lower than 1280 x 1024.z When using a USB 2.0 device, connect the device to the USB port of the computer.z The AC Adaptor (CF-AA1653A) included with the computer cannot be used for theport replicator. Contact Panasonic Technical Support.NOTEz When the expansion bus connector is not in use, be sure to close the cover until theprotuberance (B) matches up with the mark (C).The serial port B and the microphone jack of the port replicator cannot be used with thedefault settings. To be able to use the serial port B and/or the microphone jack of the portreplicator, be sure to follow the steps below.1 Run the Setup Utility. (Î page 88)Setting the Port Replicator