11Reinstalling Software “OPERATING INSTRUCTIONS (page 21)”CAUTIONBe sure not to be a disk in CD-ROM drive.1 Set the CD-ROM drive to the multimedia pocket andturn the computer on.2 When the message [Press to enter SETUP] is dis-played, press F2 and then run the Setup Utility.If the password has been set, enter the supervisor pass-word.3 Write down all of the contents of the Setup Utility andthen press F9 .At the confirmation message, select [Yes] and pressEnter .4 Select [Boot] menu, press F5 / F6 and /until [CD-ROM/DVD-ROM] is at the top of the [Boot]menu.5 Set the Product Recovery CD-ROM1.6 Press F10 .At the confirmation message, select [Yes] and pressEnter . The computer will reboot, and the LicenseAgreement screen should appear. Select [1. Yes, I agreeto the provision above and wish to continue!].7 Windows NT Windows 2000At the screen for the selection of the OS, select eitherWindows 2000 or Windows NT.You can reinstall only the initially selected OS.Replace the “Before Reinstallation” for the following. “OPERATING INSTRUCTIONS (page 21)”PreparingImportantIf you have not created the BACKUP DISK, you can create by selecting [Create BACKUP DISK] in [Start] - [Pro-grams] - [Panasonic]. If you can not create this disk, contact Panasonic Technical Support.NOTESave all important data. If reinstallation is carried out, all data existing prior to the installation will be lost. Thereinstallation will return the computer to close to the conditions at time of purchase.Before the reinstallation procedure, remove all peripherals (except for the CD-ROM drive).Be sure the AC adapter is connected until the reinstallation procedure is completed.Replace the “Reinstalling” steps for the following. “OPERATING INSTRUCTIONS (page 21)”Product Recovery CD-ROM Backup Disk you made earlier and SuperDisk driveCD-ROM driveWindows NTWindows 2000 -------------------------------------------------Select the number-------------------------------------------------1. Restore the whole HDD to factory default2. Restore Windows 2000 to the first partition3. End--------------------------------------------------------------------------------------------------Select the number-------------------------------------------------1. Restore the whole HDD to factory default2. Restore Windows NT4.0 to the first partition3. End-------------------------------------------------8 This screen should appear.9 Make a selection from the menu.To restore all contents of the hard disk to factory de-fault, including the partition setting(s):Select [1. Restore the whole HDD to factory default].To reinstall Windows NT/Windows 2000 to the firstpartition to factory default:Select [2. Restore Windows NT4.0 (or Windows 2000)to the first partition].In such cases, the initial partition size must be 4GB or more of the hard disk size. Reinstallationcannot be performed with a small partition size.If “The program has detected an error 110 on thepartition starting at sector xxxxxxxx on disk1.” isdisplayed, select [Yes].NOTE(To next page)
