Panasonic CF-55 Series Operating Instructions Manual

2 812 Delete the check mark for [When powered by AC power]in [Start] - [Settings] - [Control Panel] - [Power] - [DiskDrives], then press .8 At the [Finishing Setup], remove the floppy disk and press. Windows will restart after all the settings haveautomatically been made.9 At the [Date/Time Properties], press .1 0 At the [Add Printer Wizard], press .1 1 When the display appears indicating the establishment ofthe system settings, press .The computer will reboot. (When the welcome screen ap-pears, press .)Reinstalling SoftwareYou will need the Firstaid FD (you earlier made copies of), Firstaid CD (included), Windows 95 CD (only use enclosed CD) anda blank floppy disk for the startup disk.With the exception of the instruction below, please se-lect all default values displayed by the Setup Wizard.Be sure to add the check mark for [Sound, MIDI, orVideo Capture Card] at the [Analyzing Your Computer].Have a blank disk on hand to create a "Windows 95Startup Disk". Immediately after creating this disk, en-ter the "Firstaid FD" into the floppy disk drive and press. (Note: A system error will result if the"Firstaid FD" is not inserted. If this occurs, insert the"Firstaid FD" and press [Retry].)N O T E4 For beginners: select [2. Restore HDD to factory de-fault (For beginners)].For advanced users: select [3. Restore HDD to factory de-fault (For advanced users)]At the confirmation message, press . Simply follow theon-screen instructions .5 When your computer prompts you to insert the "Firstaid CD",please do so. When the computer reboots, the startup menuwill appear, select 2 and continue to follow the on-screen in-structions.6 When your computer prompts you to insert the "Firstaid FD",press . When the computer reboots, the startup menu willappear, select 2 and continue to follow the on-screen instruc-tions.Microsoft Windows 95 Startup Menu1. Boot2. Restore HDD to factory default (For beginners)3. Restore HDD to factory default (For advanced users)Enter a choice: 11 Insert the "Firstaid FD", and turn the computer on, then runthe Setup Utility program. ( page 34)2 Select [Load Default Settings (PnP)], then press . Atthe confirmation message, press .3 Close the Setup Utility ( page 34); this screen should ap-pear.N O T EIf you have not created these disks, a message will appear at startup urging you to make backup copies. If there is nomessage, backup copies have already been created.Before ReinstallationPreparingImportantSave all important data. If reinstallation is carried out, all data existing prior to the installation will be lost. The reinstal-lation will return the computer to factory condition.Be sure to remove all PC Cards and disconnect all peripherals before the reinstallation procedure.ReinstallingTwo options are available, one for beginners and the otherfor advanced users.C A U T I O NThe Advanced Users option should only be performed whenthe hard disk has been formatted into two or more parti-tions.If data on your hard disk is compressed, the data shouldbe uncompressed.Windows 95 (HDD format)For beginners: Returning to factory defaultcondition.For advanced users: Returning drive C to factorydefault condition.Power 1Device Manager 113 Set [Start drive letter] and [End drive letter] in [ControlPanel] - [System] - [Device Manager]- [CDROM]-[MATSHITA UJDCD8710]- [Settings] - [Reserved driveletters] to [L:], then press If the message to re-start or shut down Windows appears, select .7 When your computer prompts you to insert the "Windows 95CD", please do so.Windows 95 has setup started. Follow the on-screen instruc-tions.