Panasonic CF-71 Series Toughbook Reference Manual

Also see for CF-71 Series: Operating instructions Reference manual Operating instructions Reference manual Reference manual

28The following settings are necessary to prepare the CD-ROM pack for use:To use the CD-ROM pack in the MS-DOS mode, configure the drive following the steps belowafter performing the above steps 1 ~ 3. If the steps listed below are performed withoutcompleting steps 1 ~ 3 above first, the drive will not operate properly.1 Click the [Start] button then select [Shut Down].2 Select [Restart in MS-DOS mode] and click [OK].3 Open the "CONFIG.SYS" file for editing by issuing the following commands:cd \ Enteredit config.sys Enter4 Move the cursor to the line containing "ATAPICD.SYS" and delete the characters "rem" atthe beginning of the line. (Deleting "rem" causes the item to become valid.)DEVICEHIGH=C:\WINDOWS\COMMAND\ATAPICD.SYS /D:MSCD000(If this line is missing, add it.)5 Press Alt + F , then S to save the file. Then press Alt + F , then X to exitthe Edit program.6 Follow the same steps to edit the "AUTOEXEC.BAT" file.edit autoexec.bat Enter7 Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem" atthe beginning of the line. (Deleting "rem" causes the item to become valid.)LOADHIGH C:\WINDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L(If this line is missing, add it.)8 Press Alt + F , then S to save the file. Then press Alt + F , then X to exitthe Edit program.9 Restart the computer.1 Add the check mark for [DMA] in [Start] - [Settings] - [Control Panel] - [System] - [Device Man-ager] - [CDROM] - [TEAC CD-224E] - [Settings].2 Set [L:] for both [Start drive letter] and [End drive letter] in [Reserved drive letters].3 At the [System Properties], press [Close]. The display will ask you to restart Windows, thenpress [Yes].If the CD-ROM pack has not been accessed within 30 seconds, the drive motor will automati-cally shut down to reduce the power consumption. When the CD-ROM pack is accessed onceagain, the power of the drive motor is turned on. However, approximately 30 seconds are re-quired until data is actually read from the CD.Using a Multimedia Pocket DeviceSoftware Preparation (first time only)[Removable Disk (A:)] is displayed in [My Computer], but access is not possible. Select[Cancel].If the vibration of the CD-ROM drive is excessive, set the [CD-ROM Drive Speed] to [Low] inthe Setup Utility.NOTEUsing the CD-ROM pack in the MS-DOS modePower-saving mode