Panasonic CF-R1 SERIES Operating Instructions Manual

Also see for CF-R1 Series: Reference manual User guide User guide Reference manual Operating instructions

Dealing with Problems (Summary)DisplayNo display after powering on When there is no display to an external display,• Check your cable connection to the external display.• Confirm your display is powered on.• Check the settings for your external display.• Confirm the following setting is set to [ON].tWinclowsT2000l[Control Panel] - [Display] - [Settings] - [Advanced] - [Lynx3DM+] - [CRT][Control Panel] - [Appearance and Themes] - [Display] - [Settings] - [Advanced]- [Lynx3DM+] - [CRT]Try changing the display by pressing ( Fn ) + ( F3 ) .When displaying only through an external display, if the computer is shut down by usingthe standby or hibernation function, there will be no display on the LCD unless the exter-nal display is co nnected when operations are resumed. In this case, connect the externaldisplay or press C Fn ) + C F3 ) .The power has not beenturned off, but after a cer-tain period of time, there isno display• Has the computer been set to the power-saving mode?To resume operation of your computer from the condition the power of the display is off(for energy conservation purposes), press any key unrelated to the direct triggering of aselection, like ( ^^ift).• To save power, your computer may have automatically entered the standby or hiberna-tion mode. (Q= "Computing On the Road") Slide the power switch.• There is a possibility that an external display is set as the display destination.Press C£n!) + CUD to switch the display destina tio n.• Did you repeatedly and contin uously press C Fn 3 + C F3 ) ?Before holding down C Fn ) + C F3 J , make sure the display destination has been com-pletely switched.The cursor cannot be con-trolledRestart the computer by using the keyboard (e.g.,An afterimage appears (e.g.,green, red, and blue dotsremain on the display) orthere are dots not display-ing the correct colorsIf an image is displayed for a prolonged period of time, an afterimage may appear. Thisis not a malfunction. The afterimage will disappear when a different screen is displayed.High-precision and advanced technologies are necessary in the production of color liquidcrystal displays (color LCDs). Therefore, if 0.002% or less of the picture elements eitherfail to light or remain constantly lit (that is, more than 99.998% of elements are function-ing properly), no defect is considered to exist.The external display nolonger displays properlyWhen an external display not compatible with the power saving mode is used with thecomputer, the external display may no longer display properly when the computer enters thecondition the power of the display is OFF (for energy conservation purposes). In suchcases, turn off the power to the external display.The screen becomes disor-deredChanging the number of colors of the display may affect the screen. Restart the computer.During simultaneous dis-play, the screen of the exter-nal display becomes disor-deredTry changing the display by pressing ( Fn ] -H C F3 j.When setting theScreensaver, an error mayoccur during a resume op-erationWhen the computer enters the standby or hibernation mode while the scree nsaver is run-ning, an error may occur during a resume operation. In such cases, turn off the Screensaveror try changing the pattern of the screensaver.When an MPEG file is be-ing played with MediaPlayer, the display destina-tion cannot be switched us-ing [ Fn ) +iSet the following setting to [OFF],|Winci^200^[Start] - [Settings] - [Control Panel] - [Display] - [Settings] - [Advanced] - [Lynx3DM+][Stretch][start] - [Control Panel] - [Appearance and Themes] - [Display] - [Settings] - [Advanced][Lynx3DM+l - [Stretch]