(+)(–) (+)(–) (+)(–)(+)(–)FRONT SP REAR SPACCBATTERY 15A132S•W-OUT19ENGLISH20ENGLISH3130 CQ-C1200U/C1120U/C1110U/C1100U CQ-C1200U/C1120U/C1110U/C1100UElectrical ConnectionsCautions:• This product is designed to operate with a 12 V DC, negative ground battery system.• To prevent damage to the unit, be sure to follow the connection diagram below.• Strip about 5 mm of the lead ends for connection.• Do not insert the power connector into the unit until the wiring is completed.• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cablesand keep cable terminals free from touching any metal parts.• Remember, if your car has a drive computer or a navigation computer, the data of its memory may beerased when the battery terminals are disconnected.External Power AmplifierCY-M7052(option)RCA Cord (option)RCA Cord (option)Sub-Woofercord (monaoural)CQ-C1200U/C1120UCQ-C1110U/C1100USub-Woofer(option)Ground leadTo a clean, bare metallic part of car chassis. Battery leadTo the car battery, continuous +12 V DCPower leadTo ACC power, +12 V DCNote: This lead is used for power controlwhen an external power amplifier is con-nected. The power supply of a poweramplifier will be activated when turningon the power of this unit.Amp. relay control power lead(Max. 500 mA)This lead is for connection to the poweramplifier.Note: The power antenna extends automaticallywhen the FM/AM radio mode is selected.Motor antenna relay control lead(To motor antenna) (Max. 500 mA)This lead is not intended for use with switchactuated power antenna.(Black) (Yellow)Antenna(R) Red(L) Whitey Power connectorFuse (15 A)C(Red)(Dark blue/white stripe)(Dark blue)yPowerconnectorFuseTo removethe FuseOnly for CQ-C1200UOnly for CQ-C1200U/C1120U/C1110UExternal Power AmplifierCY-M9054(option)Speaker leadSystem upspeakers(White/blackstripe)Left speaker(Front)Right speaker(Front)Left speaker(Rear)Right speaker(Rear)(White) (Gray/blackstripe)(Gray) (Green/blackstripe)(Green) (Violet/blackstripe)(Violet)C If the fuse (rear panel) blows fre-quently, they may be somethingwrong with the unit or wiring. Consultyour nearest Panasonic Servicenterfor service.(L) White(R) RedSpeaker connections• Do not connect more than one speaker to one set of speaker leads (except forconnecting to a tweeter).• Do not use a 3-wire type speaker system having a common earth lead.LRLRPreamp. output connector (rear)Preamp. output connector (front)Note: A bridge connection should beused when connecting only 2 channelssuch as CQ-C1100U connection.