Panasonic CQ-C5305U Operating Instructions Manual

Also see for CQ-C5305U: Operating instructions Service manual

Contents

Panasonic CQ-C5305U Operating Instructions Manual Manual pdf 7 page image

CQ-C5405U/C5305U12 CQ-C5405U/C5305U 13 EnglishGeneral, Sound ControlSQ Selection Based on GenreSQ (Sound Quality)Source Selection(SOURCE)The source changes as follows every time [SOURCE]is pressed.AUX1 (AUX1 in) (3.5 mm  stereo)From line output of external sound/audio device (ex.Silicon-audio player, HDD player, etc.)GeneralVolume Off (down)Press [MUTE].CancelPress [MUTE] again.Note: You can select mute or attenuation. ( page 23) Up DownSetting Range: 0 to 40Default: 18Note: The volume level can be set independently foreach source. (For radio, one volume setting for AM, onevolume setting for all FMs)VolumeAdjustment(VOLUME)Temporary Volume Off(Down)MUTE (ATT: Attenuation)Sound ControlYou have 6 preset modes (FLAT, ROCK, POP, VOCAL,JAZZ, CLUB). You can customize your settings for theseand save them for instant recall.SQ ChangeoverPress [SQ] to activate the SQ selection mode.Press [SQ] to select the sound type as follows.Press [DISP] to return to the regular mode.Notes:• After pressing [SQ] on the main unit, you can alsoselect a sound type by pressing the preset buttons [1]to [6].• Please refer to page 22 for the adjustment to eachspeaker and an optional subwoofer.· Bass adjustment· Treble adjustment· Balance adjustment· Fader adjustment· Subwoofer level adjustment· Subwoofer low pass fi lter· Re-master settingSQ AdjustmentYou can adjust the characteristics of the currentlyselected sound type (SQ). ( above)It is also possible to preset up to 5 different adjustedSQs.SQ3 (3-Band Sound Quality)Center frequency and level are adjustable in each of3 bands. This lets you fi ne-tune sound quality for eachgenre to suit car-interior acoustics and your personalpreferences.Tone/SQ adjustable range: 12 dB to 12 dB (by 2 dB)SQ Low/Bass: ±12 dB (at 60 Hz, 80 Hz, 100 Hz,200 Hz)SQ Mid: ±12 dB (at 500 Hz, 1 kHz, 2 kHz,3 kHz)SQ High/Treble: ±12 dB (at 8 kHz, 10 kHz, 12 kHz,15 kHz)• The bass/treble control level of each frequency is fi xedto the frequency that has been selected for SQ.To return an adjusted SQ to the default settingPress [SQ], and select the SQ which is to be returnedto the default setting. (Only for main unit)Hold down [BAND] for 2 sec. or more.1 Press [VOL] (PUSH SEL:Select) to open the menu.2 Press [VOL] (PUSH SEL: Select) toselect a mode to be adjusted.3 Adjust each band./: center frequency up/down[] []: Band selection[] []: Level up/downBandLevelFrequency4 Hold down the numeric button [2] to [6]for 2 sec. or more.• The adjusted SQ is preset in the number of the selectedbutton, and return to the regular mode resumes.• When you suspend the SQ preset adjustment, each levelremains your recent adjustment until a new SQ presettingoperation is performed or you call up the SQ preset.Notes:• You cannot save any SQ presetting value in [1] button.• Any SQ adjustments will not change the call up screennames such as ROCK and JAZZ.• Do not activate SQ and Bass/Treble at the same time toavoid causing sound distortion.(FLAT) flat frequency response:does not emphasize any part. (Default)(ROCK) speedy and heavy sound:exaggerates bass and treble.(POP) wide-ranged and deep sound:slightly emphasizes bass and treble.(VOCAL) clear sound:emphasizes middle tone and slightlyemphasizes treble.(JAZZ) jazz-specific deep sound:sound with emphasis on sharpness of high-hat and echo saxophone.(CLUB) club and disco-specific sound:reproduction of realism being in a club.Caution• Set the volume level to low enough before theAUX connection is completed.Failure to observe this, the loud noise may comeout and damage your speakers and your hearing.RadioFM1, FM2, FM3, AM ( page 14)PlayerWhen loading CD ( page 16)When loading MP3/WMA/AAC disc ( page 18)AUX1Device connected to the AUX1 terminal of this unitWhen an optional device is connected:Shift to connected deviceWhen connecting CD changerWhen connecting iPodWhen connecting XM ReceiverWhen connecting Sirius ReceiverORWhen an expansion module is connected:The devices connected to the ports 1 to 4 areactivated in sequence after shifting to AUX2 (deviceconnected to the AUX terminal of the expansionmodule).Note: For information about connectable devices, referto the System Upgrade Guidebook or the instructionmanual for each device.System-up Connector