Panasonic CQ-DF601U Operating Instructions Manual

Contents

Panasonic CQ-DF601U Operating Instructions Manual Manual pdf 21 page image

ENGLISH32CQ-DF801/DFX701/DF601U 41ENGLISH31CQ-DF801/DFX701/DF601U40TroubleshootingCD is dirty.➡Clean CD, referring to the section on “Notes on CD”.Mounting angle is over 30o.➡Adjust mounting angle to less than 30o.Instable mounting.➡Mount the unit securely with the mounting parts, referring to thesection on installation.≥ CD is defective.≥ Mechanical trouble.➡Press [OPEN] to open the panel and press [<] (EJECT). If normaloperation is not restored yet, call the store where you purchasedthe unit or the nearest service station to ask for repairs.CD sound skips, tonequality is low.Sound skips due to vi-bration.CD is not ejected.CD is in the CD compart-ment but no sound ismade, or CD is ejectedautomatically.CD is upside down.➡Place CD in the correct direction, and the label side up.❐ CDCD is dirty.➡Clean CD, referring to the section on “Notes on CD”.Trouble Cause/StepNo sound from left,right, front or rearspeakers.Left and right balance, or front and rear balance is off on one side.➡Adjust BAL/FAD mode as appropriate.❐ Sound SettingThe right speaker wire is connected to the left speaker and the leftspeaker wire to the right speaker.➡Connect the speaker wires to the correct ones.Left and right sounds arereversed in stereo lis-tening.Trouble Cause/StepCables are not correctly connected.➡Connect the cables correctly.❐ RadioMuch noise in FM stereoand monaural broad-casts.Station is too far, or signals are too weak.➡Select other stations of higher signal level.The radio antenna is not extended enough.➡Set the radio antenna enough.Battery cable is not correctly connected.➡Connect the battery cable to the terminal that is always live.Preset station is reset.Trouble Cause/StepPreliminary StepsCheck and take steps as described in the tables below.If You Suspect Something WrongImmediately switch power off.Disconnect the power connector and check that there is nei-ther smoke nor heat from the unit before asking for repairs.Never try to repair the unit yourself because it is dangerous todo so.No power.TroubleCar’s engine switch is not on.➡Turn your car’s ignition switch to ACC or ON.Troubleshooting Tips❐ CommonCables are not correctly connected.➡Connect cables correctly.Battery cable is not correctly connected.➡Connect the battery cable to the terminal that is always live.Accessory cable is not correctly connected.➡Connect the accessory cable to your car’s ACC source.Grounding wire is not correctly connected.➡Connect the grounding wire to a metal part of the car.Fuse is burnt.➡Call the store where you purchased the unit, or your nearest servicestation (see the attached sheet) and ask for fuse replacement.No sound.Mute is set to ON.➡Set it to OFF.Cables are not correctly connected.➡Connect cables correctly.Condensation (dew)➡Wait for a while before use.Cautions:≥ Do not use the unit if it malfunctions oris something wrong.≥ Do not use the unit in abnormal condi-tion, for example, without sound, orwith smoke or foul smell, can cause ig-nition or electric shock. Immediatelystop using it and call the store whereyou purchased it.Cause/StepThe display shows “display and light off”.➡Press [DISP] to change the display.Only sound, no display.A mobile phone is used near the unit.➡Keep the mobile phone away from the unit.Noise.Demonstration mode is ON.➡Press [DISP] to cancel demonstration mode.≥ Buttons unusable.≥ Audio sound is notmatched on themode display.3z (8 cm) disc is ejected automatically.