Panasonic CQ-DF601U Operating Instructions Manual

Contents

Panasonic CQ-DF601U Operating Instructions Manual Manual pdf 9 page image

ENGLISH8CQ-DF801/DFX701/DF601U 17ENGLISH7CQ-DF801/DFX701/DF601U16RadioBandPress [BAND] to change the band.2Radio ModePress [SOURCE] to change to the radio mode.1Tuning[TUNE $]/[$]: Up[TUNE %]/[%]: DownPress and hold [TUNE $] or [TUNE %]/[$] or[%] for more than 0.5 seconds, then release.Seeking will start.3One-Touch Selection of a Preset StationUp to 6 stations each can be saved in the FM1, FM2, FM3 and AM preset station memories.Manual PresetMemoryManually save a sta-tion in the presetmemoryEntering Numbers Directly from the Remote ControlSelect a band and frequency (step 1, 2 and 3 on the previous page).Press and hold [1] to [6] on the remote control for more than 2 sec-onds to memorize.123Auto PresetMemory (APM)Automatically savestrong stations in thepreset memorySelect a band (steps 1 and 2 on theprevious page).Press and hold [BAND] (APM) formore than 2 seconds.Note:≥ New stations are overwritten on existing saved stations after following this procedure.Preset StationCallingSelect a band (steps 1 and 2 on the previous page).Press [P. SET "] or [P. SET #]/["] or [#] to select the presetnumber for tuning in the preset station.Entering Numbers Directly from the Remote ControlPress [1] to [6] on the remote control.VOLMENUTUNESOURCED•MCQ-DF801UCD RECEIVER WIITH FULL DOT MATRIX DISPLAYDIMOPENTRACKDISCP•SETBANDREMOTE SET/APMMUTEDISPCH•C!@MOSFET 60W X 4S•HDBHDB;/ 1PWR[SOURCE][%] [$](TUNE)[1] to [6]Preset button[BAND]["] [#](PRESETMEMORY)(SELECT)SELCar AudioSOURCEPOWERVOLMENUDISPMUTE246RANDREP135SCANBANDFM1FM2FM3SourceAMNote:≥ Frequency setting can be performed even after selecting a preset num-ber.Select a band and frequency (steps 1, 2 and 3 on the previouspage).Press and hold [P. SET "] or [P. SET #]/["] or [#] for more than2 seconds until the preset number blinks.Press [P. SET "] or [P. SET #]/["] or [#] to select a preset num-ber.Press and hold [P. SET "] or [P. SET #]/["] or [#] for more than2 seconds to memorize.Direct MemoryYour favorite radio station can be memorized in[D•M] on the main unit.Default: FM 87.9 MHzMemorizeRecalling the Direct MemorySelect a band and frequency (steps 1, 2 and3).Press and hold [D•M] for more than 2 sec-onds.Frequency blinks once and is saved in thememory.Press [D•M].12Scanning:Radio mode displayPress [D•M] again to cancel and return to the pre-vious source.Note:≥ You can recall the direct memory when thepower is off.FM stereo indicator12≥ The display blinks once, and a re-ceiving station is saved in thememory. Preset number≥ The 6 strongest available stations will be automatically saved in thememory under preset number 1 to 6.≥ Once set, the preset stations are sequentially scanned for 5 secondseach.≥ Press [P. SET "] or [P. SET #]/["] or [#] for the broadcast youwant to listen to.(Press [1] to [6] on the remote control.)12124Note:≥ The new station is overwritten on existing savedstations after following this procedure.