Panasonic CQ-DF602W Operating Instructions Manual

Also see for CQ-DF602W: Operating instructions

Contents

ENGLISH2CQ-DF602W 11GeneralENGLISH1CQ-DF602W10Before Reading these InstructionsYou can operate this unit by pressing buttons on the main unit and the remote control unit.∫ These instructions describe buttons that are concerned with operations as follows.Example: Press [P·SET "] or [P·SET #]/["] or [#].∫ Some operations can be activated by pressing buttons only on main unit or remote control unit.Those cases are described in the instructions.Example: Press [OPEN] on the main unit.Battery Installation1 Remove the battery holder.Pull the battery holder by the position B while pushingposition A in the direction indicated by the arrow.2 Install the battery on the battery holder.Set a new battery properly with its “i” side facing upas shown in the figure.3 Insert the battery holder.Push the battery holder back into its original position.Battery NotesRemove and dispose of an old battery immediately.Battery Information:≥ Battery type: Panasonic lithium battery (CR2025) (included)≥ Battery life: Approximately 6 months with normal use (at room temperature)≥ Do not disassemble or short the battery. Do not throw a battery into a fire.≥ Keep batteries away from children to avoid the risk of accidents.≥ Be careful to observe proper local disposal rules when you dispose of batteries.Caution:≥ Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.Battery leakage may damage the unit.[buttons on the main unit]/[remote control unit]Point the remote control unit at the main unit’s sensor.Remote Control Unit PreparationLithium battery(included)Back sidePosition BPosition ABattery holderNote:≥ When the power is switched on for thefirst time, a demonstration message ap-pears on the display.To cancel this display, press [DISP] (dis-play).ACCON[SOURCE](POWER)[DISP](Display)PowerTurn the key in the ignition until the accessory in-dicator lights.ON: Press [SRC] (PWR)/[SOURCE] (POWER).OFF:Press and hold [SRC] (PWR)/[SOURCE](POWER) again for more than 1 second.≥ After turning off the ignition key, a securitymessage is displayed, and the panel removablealarm that reminds you to take the panel is acti-vated.(When security function is set to on ➡ page 28)1SourcePress [SRC] (SOURCE)/[SOURCE] to change the source.2RadioCD playerCD changer controlAUX-IN setting(When a CD is in the player.)(When a CD changer is con-nected and magazine is in thechanger.) (➡ page 20)SRCDISP P.SETCQ-DF602WN 5O 6WX; / 1OPENBANDTUNETRACKPWRMUTEPUSHCD RECEIVER WITH FULL DOT MATRIX DISPLAYDISCSET/APMMENUVOLUMESOURCEMOSFET50W X 4Remote control signal sensor