Panasonic CQ-DF602W Operating Instructions Manual

Also see for CQ-DF602W: Operating instructions

Contents

ENGLISH6CQ-DF602W 15ENGLISH5CQ-DF602W14RadioBandPress [BAND] to change the band.2Radio ModePress [SRC] (SOURCE)/[SOURCE] to change tothe radio mode.1Tuning[TUNE $]/[$]: Up[TUNE %]/[%]: DownPress and hold [TUNE $] or [TUNE %]/[$] or[%] for more than 0.5 seconds, then release.Seeking will start.3[SOURCE]["] [#](Preset station/select)[%] [$] (Tune)[1] to [6](Preset station)[BAND](Auto preset memory)FM1 FM2FM3AMRadio mode displayFM stereo indicatorOne-Touch Selection of a Preset StationUp to 6 stations each can be saved in the FM1, FM2, FM3 and AM preset station memories.Manual PresetMemoryManually save a station inthe preset memory.Entering numbers directly on the remote control unit1 Select a band and frequency (step 1, 2 and 3 on the previouspage).2 Press and hold [1] to [6] for more than 2 seconds to memorize.Auto PresetMemory (APM)Automatically save rela-tively strong stations inthe preset memory.1 Select a band (steps 1 and 2 onthe previous page).2 Press and hold [BAND] (APM) formore than 2 seconds.Note:≥ Existing saved stations are overwritten with new stations after following this procedure.Preset StationCalling1 Select a band (steps 1 and 2 on the previous page).2 Press [P·SET "] or [P·SET #]/["] or [#] to select the presetnumber for tuning in the preset station.(Press [1] to [6] on the remote control unit.)Note:≥ Frequency setting can be performed even after selecting a preset number.1 Select a band and frequency (steps 1, 2 and 3 on the previouspage).2 Press and hold [P·SET "] or [P·SET #]/["] or [#] for more than2 seconds until the preset number blinks.3 Press [P·SET "] or [P·SET #]/["] or [#] to select a preset num-ber (1j6).4 Press and hold [P·SET "] or [P·SET #]/["] or [#] for more than2 seconds to memorize.Scanning:≥ The display blinks once, and a re-ceiving station is saved in thememory. Preset number≥ The 6 strongest available stations will be automatically saved in the mem-ory under preset number 1 to 6.≥ Once set, the preset stations are sequentially scanned for 5 secondseach. (Scanning)≥ Press [P·SET "] or [P·SET #]/["] or [#] for the broadcast you wantto listen to.(Press [1] to [6] on the remote control unit.)Caution:≥ To ensure safety, never attempt to preset sta-tions while you are driving.[P·SET "] [P·SET #](Preset station/select)SRCDISP P.SETCQ-DF602WN 5O 6WX; / 1OPENBANDTUNETRACKPWRMUTEPUSHCD RECEIVER WITH FULL DOT MATRIX DISPLAYDISCSET/APMMENUVOLUMESOURCEMOSFET50W X 4Note:≥ When pressing [MENU] in radio mode,the following display appears. This isbecause radio mode does not have anymenu settings.