CQ-DX100W2Safety InformationWarning❐ This installation information is designed for professional installers with knowledge of automobile electrical safety sys-tems and is not intended for non-technical, do-it-yourself individuals. It does not contain instructions on the electricalinstallation and avoidance of potential harm to air bag, anti-theft and ABS braking or other systems necessary to installthis product. Any attempt to install this product in a motor vehicle by anyone other than a professional installer couldcause damage to the electrical safety system and could result in serious personal injury or death.❐ If your car is equipped with air bag and/or anti-theft systems, specific procedures may be required for connection anddisconnection of the battery to install this product. Before attempting installation of this electronic component againstthe manufacturer’s recommendation, you must contact your car dealer or manufacturer to determine the required proce-dure and strictly follow their instructions.FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOYMENT OF AIR BAGS OR ACTIVA-TION OF THE ANTI-THEFT SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND PERSONAL INJURY OR DEATH.53 mm182 mm4.5 mm – 6.0 mm0 – 30°Consult a professional for installation.Verify the radio using the antenna and speakers before installation.Mounting Angle Mounting Spaceside to side : horizontalfront to rear : 0 – 30°Supplied Hardware111121Mounting CollarMounting Bolt (5 mmø)Rubber BushingTrim PlatePower ConnectorLock Cancel PlateNo. Diagram Q'tyItem No. Diagram Q'tyItem11Conversion Cablefor AV1 INClip Connector* w, e, y and i consist of a set. (ZZBISDX200W)(YFC054C095CA)(FX0214C384ZB) (YAJ024C126CA)(YEAERA33000K)182 mm53 mm4.5 mm – 6 mm¡ Exclusively operated with 12 V battery with negative(–) ground.¡ Connect the power lead (red) very last.¡ Connect the battery lead (yellow) to the positive (+)terminal of the battery or fuse block terminal (BAT).¡ Apply insulating tape to bare leads.¡ Secure loosened leads.Before InstallationBefore Wiring