Panasonic CQ-DX200W Operating Instructions Manual

Also see for CQ-DX200W: Installation instructions

Panasonic CQ-DX200W Operating Instructions Manual Manual pdf 37 page image

37CQ-DX200WEnglish5. TV TypeTV standard format (PAL/NTSC) setting(Default: NTSC (CQ-DX200W3)/PAL (CQ-DX200W5))Note: Setting should be made to match the format of theconnected monitor. Select NTSC if connections are madepossible for both NTSC and PAL. If you select PAL, apicture may be partly omitted.1. NTSC The unit transmits the NTSC formattedsignal in either case, playing an NTSCformatted video or a PAL formatted video.2. PAL The unit transmits the PAL formatted signalin either case, playing an NTSC formattedvideo or a PAL formatted video.3. Multi The unit transmits the same video signal asthe output of playing video software.Note: If the connected monitor cannotautomatically select between NTSC and PALaccording to the video signal of the disc tobe reproduced, images on the screen maybe distorted. Select NTSC or PAL at themonitor side depending on the disc to bereproduced.4. Return The display returns to “Setup Menu”.Note: Holding down the [OSD] button on the remotecontrol for 2 sec. or more before disc play allows usersto toggle between NTSC and PAL.6. TV DisplayDisplay aspect setting(Default: WIDE)1. WIDE (16:9) Plays in the Wide mode when awide-screen monitor isconnected.2. Pan & Scan (4:3) Plays in the Pan & Scan modewhen a conventional monitor isconnected.3. Letterbox (4:3) Plays in the Letterbox modewhen a conventional monitor isconnected.4. Return The display returns to “SetupMenu”.Note: If “Pan & Scan” or “Letterbox” is already set inthe software, this setting shall be ignored.7. On-Screen MessagesThis is to select On-screen Display messages which willbe displayed when On-screen Display is turned off bypressing [OSD]. (a Page 30)(Default: ON)1. ON When the power is turned on, On-ScreenDisplay message such as “Play” and“Pause” will be displayed on the screen for5 seconds.2. OFF When the power is turned on, On-ScreenDisplay messages such as “Play” and“Pause” will not be displayed on the screen.3. Return The display returns to “Setup Menu”.8. D.Range CompressionBy compressing the range of the playback level (thedynamic range), it is possible to maintain the impact ofaudio even at low volumes.This function only works with Dolby Digital encodedmaterial.(Default: OFF)1. Minimum Most compressed mode: TVbroadcasts,etc2. Standard Mode recommended by softwarecreators for listening at low volumes.3. OFF Not compressed dynamic range4. Return The display returns to “Setup Menu”.Note: When it is difficult to hear comparatively smallsound (such as movie dialogue), selection of “Minimum”will make those sounds easier to hear.9. DivX Registration(a Page 28)To return to the “Setup Menu” display, press[RETURN]. display (continued)User Settings[0](Finish the setting.)Numeric buttons[1] – [9][MENU]