13CQ-RXBT490W/CR-LXBT490WRadio (AM/FM)Operation Flow1 Press [SOURCE] to select the radio source.2 Press [BAND] to select a band.3 Select a station.Frequency Adjustment[6]: Lower / [7]: HigherNote: For station search, hold down either of the but-tons for more than 0.5 seconds and release it.Preset Station SelectionPress the corresponding preset button from [1]through [6] to tune in a preset station.Radio Source DisplayBand Frequency Preset Numberlights while receiving an FM stereo signal.lights while receiving an FM stereo signal.Display ChangePress [DISP] to change the display.Radio mode display(Frequency)cdClock display SStation PresetUp to 6 stations can be preset in each of AM, FM1,FM2, and FM3.Preset stations can be simply called up by pressing [1]through [6].Auto Preset Memory (APM)With this operation, stations with good receivingconditions can be automatically stored in the presetmemory.1 Select a band.2 Hold down [BAND] (APM) for more than 2seconds.The preset stations under best receiving conditionsare received for 5 seconds each after presetting thestations (SCAN). To stop scanning, press one of thebuttons from [1] through [6].Note: New stations overwrite existing saved stations.Manual Station Preset1 Tune into a station.2 Hold down one of the preset buttons from [1]through [6] for more than 2 seconds.(blinks once)Note: New stations overwrite existing saved stations.CautionTo ensure safety, never attemptto preset stations while you aredriving.[SOURCE]selects a source.[DISP] (Display)switches the informationon the display.[BAND]selects a band in the radio source.(APM) (Auto Preset Memory)executes APM in the radio source(by holding it down for more than 2seconds).[6] [7]decreases/increases the frequency. (For seek tuning, hold itdown for more than 0.5 seconds and release it.)Preset buttons [1] through [6]select a preset station in the radio source,preset the current station (by holding it downfor more than 2 seconds).[SOURCE]selects a source.