Panasonic CQ-SRX7000U Operating Instructions Manual

Also see for CQSRX7000U - SD CAR AUDIO: Operating instructions

46 CQ-SRX7000U37ENGLISHBATTERY 10AACCTWIN CD·C-CONTNAVI MUTEANT-CONT MAX 0.1AILLUMINATIONAMP-CONT MAX 0.1ANavi Mute LeadConnect to the Navi Mute Lead of the Panasoniccar navigation system (not available yet).Note: Insulate the Navi Mute Lead with vinyl tapewhen you do not connect it.Antenna Control CordTo the auto antenna control powercord of the carIllumination LeadTo the power line connected tothe side marker lights of the carExternal Amplifier Control Power LeadTo an external amplifierACC Power LeadTo ACC power, +12V DC(Orange)CD ChangerControlConnectorAntennae Power Connector(Blue)(Yellow) Fuse (10A)(Red) Resistor (1kΩ)(Black)(Orange / white stripe)(Brown / white stripe)(Blue / white stripe)Battery LeadTo the car battery, continuous+12V DCGround LeadTo a clean, bare metallic part ofthe car chassisDual CD Changer Control Lead (not used)Note: Insulate the Dual CD Changer ControlLead with vinyl tape.Note: If your car does not have a power line connected to the side marker lights of the car, leave the illumination lead disconnected.SD/CD ReceiverCQ-SRX7000U(Rear)Cautions:¡This product is designed to operate off a 12 volt, negative ground battery system.¡To prevent damage to the unit, be sure to follow the connection diagram bellow.¡Remove approx. 1/4” (5 mm) of protective covering from the ends of the leads before connecting.¡Do not insert the power connector into the unit until the wiring is completed.¡Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keepcable terminals free from touching any metal parts.¡Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased whenthe battery terminals are disconnected.Electrical ConnectionsSupplied hardwareNo. Item Q’tye Power Connector 1❏ Wiring Diagram