Panasonic CQ-VA7800N Operating Instructions Manual

Panasonic CQ-VA7800N Operating Instructions Manual Manual pdf 7 page image

199ENGLISH10ENGLISH18 CQ-VA7800N CQ-VA7800NPWRMODECH 114780#ENTERMUTELOUDVOLUMECAR AVNAVINAVIGATIONSCROLLDISPASPECTMENUP·MODE95623RANDOM SCANREPEATCH 2MUTEPWRCautions:¡For smooth adjustment, make sure to first return the lateral angle to the neutral position and then adjust the tilt angle.¡Avoid physical shock on the display.Caution: Do not interfere with the movement of the dis-play. Do not change the position of the unit forcibly.Cautions:¡Do not place any object on the display unit, or subject itto undue force.¡Do not move the display forcibly.¡The monitor movable range may be limited by a type ofcar, a position where the display is mounted, etc.Display Position AdjustmentTilt AnglePress and hold [TILT] on the display unit for more than2 seconds.Press []] or [[] to adjust.The setup is the same way as the one from MENU.Refer to “User Settings” for details. (a page 28)Folding Down the DisplayTemporarilyFold Down: Press [TILT] on the display unit.Raise: Press [TILT] again on the display unit.Note: Even when the unit is power off, you can fold down thedisplay temporarily.2Notes:¡Vertical angle (TILT) data are saved in the memory, so whenthe display unit is drawn out next, it is automatically set atthe angle adjusted before.¡After adjusting its angle, also adjust the brightness to makeit easy for you to watch. (a page 38)¡The car model and installation condition may impose somerestrictions on the adjustment of the display’s angle.1Display Open/CloseOPEN: Press [ ] (OPEN/CLOSE).CLOSE: Press [ ] (OPEN/CLOSE) again.Notes:¡When the display unit is opened or closed, a loudbeep sounds three times.¡If the unit stops halfway, press [ ] (OPEN/CLOSE)again and draw it all the way in.¡Opening/closing the display can also be done whenthe power is off.PowerTurn your car’s ignition key to ACC or ON position.ON: Press [MODE] (POWER) on the display unit.Press [PWR] or [MODE] on the remote control.OFF: Press [MODE] (POWER) again for more than 2seconds on the display unit.Press [PWR] again or [MODE] again for more than 2seconds on the remote control.Warning:¡Do not touch the unit while the display is mov-ing. Inserting hands, fingers or foreign objectsinto the unit can cause injuries and damage tothe unit.¡Keep babies and children away from the unit.General[VOL}] [VOL{][MUTE](LOUD)[ ] (OPEN/CLOSE)[MODE][MODE](POWER)[MUTE](LOUD)[}] [{] (VOLUME)ModePress [MODE] to change the mode.*1 VTR1/VTR2 can be skipped when no external devicesare connected. (a page 32)*2 Selectable only when the CD Changer or Video CDChanger are connected.VOLVOLVOLNAVINAVIGATIONASPASPECTTILTMUTEMUTEMUTEDISP P SCRLSCROLLP • MODEENTERMODEPOWERMENUIN-DASH 7 INCH WIDE COLOR LCD TV WITH RECEIVERCQ-VA7800NLOUDOPEN / CLOSECHANNEL/TRACKDISCVOL MUTEMODEVolume[VOL}]: Increase[VOL{]: DecreaseSetting Range : 0 to 40Note: The volume level can be set independently for each source.(For radio, one volume setting for AM, one volume setting for all FMs)MuteMUTE ON: Press [MUTE].MUTE OFF: Press [MUTE] again.LoudnessWhen listening at low or medium volume, enhance bass and treble tones.LOUD ON: Press and hold [MUTE] (LOUD) for more than 2 seconds.LOUD OFF: Press and hold [MUTE] (LOUD) for more than 2 secondsagain.Note: The setup is the same way as the one from MENU.Refer to “Sound Settings” for details. (a page 36)VTR 1 * 1TV (a page 20)(a page 22)(a page 22)(a page 24)(a page 26)CH-C (CD Changer/Video CDChanger Control) *2VTR 2 * 1AM/FM (Radio)[PWR](Power)[TILT][] ] [[ ](Adjust)PWRMODECH 114780#ENTERMUTELOUDVOLUMECAR AVNAVINAVIGATIONSCROLLDISPASPECTMENUP·MODE95623RANDOM SCANREPEATCH 2[] ] [[ ](Adjust)VOLVOLVOLNAVINAVIGATIONASPASPECTTILTMUTEMUTEMUTEDISP P SCRLSCROLLP • MODEENTERMODEPOWERMENUIN-DASH 7 INCH WIDE COLOR LCD TV WITH RECEIVERCQ-VA7300NLOUDCHANNEL/TRACKDISCOPEN / CLOSECQ-VA7800NASPECT TILT