Panasonic CQ-VD7003W2 Operating Instructions Manual

Panasonic CQ-VD7003W2 Operating Instructions Manual Manual pdf 7 page image

78 CQ-VD7003WEnglish Preparation(user settings) ( a page 30)display unit, clock, ID code, memory clear, other(screen settings) (a page 32)dimmer, picture(audio settings) (a page 32)sound setup, graphic equalizer, CS Auto, speaker setup,speaker level, time alignment, source level, cross over(DVD settings) (a page 36)language, display, pro logic, down mix, dynamic rangecompression, multiple channel(AV-IN/OUT settings) (a page 37)source skip(radio settings) (a page 38)FM set up, AM set upNote:¡Refer to “Settings” (a page 28) for further informationabout operations, settings, and others of the menuscreen.RADIOINPUT/OUTPUTDVDAUDIOSCREENUSERYou may need to set the following depending on thedevices to be connected.Subwoofer¡Execute (speaker set up) and(speaker level). (a page 34)Other speakers¡Execute (speaker set up). (a page 34)AV1/AV2 (Camcorder,VCR, etc.)¡Adjust (AV1/AV2 input level).(a page 35)SOURCE LEVELSP SETUPSP LEVELSP SETUPSettingsWarning¡When you connect external devices to AV1-IN/AV2-IN (AV1/AV2), be sure to connect the sidebrake connection lead (aInstallation Instructions).Please refer to the separate “System UpgradeGuidebook” for how to operate this unit when option-al devices are connected.23Lithium battery(CR2025: supplied)Battery caseRemote Control UnitWarning¡Keep batteries away from children to avoid the riskof accidents. If an infant ingests a battery, pleaseseek immediate medical attention.Caution¡Remove and dispose of an old battery immediately.¡Do not disassemble, heat or short a battery. Do notthrow a battery into a fire or water.¡Follow local regulations when disposing of a battery.¡Improper use of a battery may cause overheating, anexplosion or ignition, resulting in injury or a fire.Note:¡Battery Information:Battery Type: Panasonic lithium battery (CR2025)Battery Life: Approximately 6 months under normaluse (at room temperature)Battery Replacementq Remove the battery holder with the remote controlunit placed on a flat surface.q Stick your thumbnail into the groove and push theholder in the direction of the arrow at the sametime.w Pull it out in the direction of the arrow using atough pointed object.Before Initial UsePull the insulation film out fromthe backside of the remote con-trol gently.w Put a battery in the case with (+)-side facing up.e Put the case back.Tough pointed object