23Lithium battery(CR2025)Battery case910 CQ-VD7005UEnglish PreparationYou may need to set the following depending on thedevices to be connected.Subwoofer¡Execute (speaker level). (a page 36)AV1/AV2 (Camcorder, VCR, etc.)¡Adjust (AV1/AV2 input level).(a page 37)SOURCE LEVELSP LEVELRemote Control UnitOther SettingsFirst Time Power OnWarning¡When you connect external devices to AV1-IN/AV2-IN (AV1/AV2), be sure to connect the sidebrake connection lead (aInstallation Instructions).Warning¡Keep batteries away from children to avoid the riskof accidents. If an infant ingests a battery, pleaseseek immediate medical attention.Caution¡Remove and dispose of an old battery immediately.¡Do not disassemble, heat or short a battery. Do notthrow a battery into a fire or water.¡Follow local regulations when disposing of a battery.¡Improper use of a battery may cause overheating, anexplosion or ignition, resulting in injury or a fire.Note:¡Battery Information:Battery Type: Panasonic lithium battery (CR2025)Battery Life: Approximately 6 months under normaluse (at room temperature)Battery Replacementq Remove the battery holder with the remote controlunit placed on a flat surface.q Stick your thumbnail into the groove and push theholder in the direction of the arrow at the sametime.w Pull it out in the direction of the arrow using atough pointed object.Before Initial UsePull the insulation film out from thebackside of the remote control gently.w Put a battery in the case with (+)-side facing up.e Put the case back.Tough pointed objectPlease refer to the separate “System UpgradeGuidebook” for how to operate this unit when option-al devices are connected.(user settings)( a page 32)display unit, clock, ID code, memory clear, other(screen settings)(a page 34)dimmer, picture(audio settings)(a page 34)sound setup, graphic equalizer, CS Auto, speaker setup,speaker level, time alignment, source level, cross over(DVD settings)(a page 38)language, display, pro logic, down mix, dynamic rangecompression, multiple channel(AV-IN/OUT settings)(a page 39)source skip(radio settings)(a page 40)FM set up, AM set upNote:¡Refer to “Settings” (a page 30) for further informa-tion about operations, settings, and others of themenu screen.RADIOINPUT/OUTPUTDVDAUDIOSCREENUSERThe speaker setup screen appears after the opening dis-play when the power is turned on for the first time.Perform speaker setup according to the car conditions inwhich this unit is installed. ( a page 36)SP SETUPNoticeThis product contains a CR Coin Cell Lithium Batterywhich contains Perchlorate Material - special handlingmay apply.See www.dtsc.ca.gov/hazardouswaste/perchlorate.