10 English11CQ-VX220LAnti-Theft SystemCaution¡ Be sure to follow the procedure mentioned above to mount the face plate appropriately. Improper mounting suchas forcible mounting without engaging the concave parts with the convex parts may cause trouble.¡ Use caution not to damage the detection switch while mounting the face plate. Failure to observe this may causetrouble.¡ Use caution not to apply excessive force to the removed face plate when the plate is carried or stored. Failure toobserve this may cause trouble.¡ This face plate is not waterproof. Do not expose it to water or excessive moisture.¡ Do not remove the face plate while driving your car.¡ Do not place the face plate on the dashboard or nearby areas where the temperature rises high.Face Plate Removal AlarmThis alarm sounds to warn you not to forget to removethe face plate before leaving your car.This function is activated when is set to). (a page 35)OnSecurity AlarmTILTCQ-VX220LDIMMER DIMTUNE/TRACKMUTE SETUP SOURCEPOWERVOLPUSH SELAV1 INOPENThis unit is equipped with a removable face plate.Removing this face plate makes the unit totally inopera-ble.Install the Face Plateq Engage the right and left concave parts (A) on thelower rear side of the face plate with the convex parts(B) of the main unit.w Raise and press the face plate toward the main unituntil a click is heard while engaging (A) with (B).Removable face plateRemove the Face Plateq Switch off the power of the unit.w Hold the top and bottom of the center part of the faceplate and pull it down toward you.e Pull the face plate toward you.r Place the face plate into the case and take it with youwhen you leave the car.we(B)(B)(A)(A)qwDetection switch