Panasonic CS-KE12NB41 Installation Instructions Manual

Also see for CS-KE12NB41: Technical & service manual

Contents

Panasonic CS-KE12NB41 Installation Instructions Manual Manual pdf 15 page image

14When connecting each power wire to the corresponding terminal, fol-low the instructions “How to connect wiring to the terminal” and fastenthe wire securely tight with the fixing screw of the terminal plate.How to connect wiring to the terminala) For Indoor Unit(1) Cut the wire end with a cutting pliers, then strip the insulation toexpose the wire about 9/32" (7 mm). See the label (Fig. 9) near theterminal plate.(2) Using a screwdriver, loosen the terminal screw on the terminalplate.(3) Insert the wire and tighten the terminal screw completely using ascrewdriver.b) For Outdoor Unit For solid core wiring (or F-cable)(1) Cut the wire end with a cutting pliers, then strip the insulation toexpose the solid wire about 15/16"(25 mm). (Fig. 10)(2) Using a screwdriver, remove the terminal screw(s) on the terminalplate.(3) Using the pliers, bend the solid wire to form a loop suitable for theterminal screw.(4) Shape the loop wire properly, place it on the terminal plate and fixit securely with the removed terminal screw using a screwdriver.Loose wiring may cause the ter-minal to overheat or result in unitmalfunction. A fire hazard mayalso exist. Therefore, be sure allwiring is tightly connected.WARNINGFig. 9STRIPSIZE9/32"(7 mm) (ACTUALSIZE)Fig. 8Fig. 10Solid wireLoopInsulationStrip 15/16" (25 mm)1 32Earth screwClamping strap(Conduit)Inter unitPower wiring(Locally purchased)3-9. Wiring Instructions for Inter-unit Connections(1) Remove the 1 screw from the terminal cover, then open thecover. Be careful that the cover does not fall.(2) Remove the 3 screws from the power box cover, then openthe cover. Be careful that the cover does not fall.(3) Use the screw to securely fasten the ground wire from theoutdoor unit in place.(4) Remove the transparent plastic cover from the 3P terminalplate.(5) While viewing the wiring diagram, connect the inter-unit andpower supply line to terminals 1, 2 and 3 on the 3P terminalplate.(6) Remount the transparent plastic cover onto the 3P terminalplate.(7) Be sure to use the clamping strap to fasten the wires in place.(8) Tighten the screws to remount the terminal and the powerbox cover.