Panasonic CS-KS18NKU Operating Instructions Manual

Also see for CS-KS18NKU: Technical & service manual

Contents

Panasonic CS-KS18NKU Operating Instructions Manual Manual pdf 10 page image

10REMOTE CONTROLLER (CONTINUED)USING THE REMOTE CONTROLLERTemperature Display Selector button This switches the temperature display between °C and °F.Time Display Selector button This switches the time display between 24-hour time and 12-hour time.ACL button (ALL CLEAR) Puts the remote controller into pre-operation status. Always press this buttonafter replacing the batteries.ADDRESS switch • The address switch changes to prevent mixing of signals from remotecontroller’s when two air conditioners are installed next to each other.Normally, the address switch is set to A. For more information, please contactthe dealer where you made the purchase.• Normally, the tabs on the remote controller should not be bent.The remote controller sends the temperature signal to the air conditioner regularly at five minute intervals.If the signal from the remote controller stops for more than 15 minutes due to the loss of the remotecontroller or other trouble, the air conditioner will switch to the temperature sensor which is built into theindoor unit and control the room temperature. In these cases, the temperature around the remotecontroller may differ from the temperature detected at the air conditioner’s position.How to Install Batteries• The batteries last about six months, depending on how much you usethe remote controller. Replace the batteries when the remote controller’sdisplay fails to light, or when the remote controller cannot be used tochange the air conditioner’s settings.• Use two fresh leak-proof type-AAA alkaline batteries.• In replacing batteries, follow the instructions as mentioned in thesubsection “How to Install Batteries”.• If you do not use the remote controller more than 1 month, take out thebatteries.• Dispose of the used batteries at the designated location in compliancewith the applicable local ordinances.Information for Users on Collection and Disposal of Old Equipment and used Batteries[Information on Disposal in otherCountries outside the European Union]These symbols are only valid in theEuropean Union. If you wish to discard theseitems, please contact your local authoritiesor dealer and ask for the correct method ofdisposal.Note for the battery symbol (bottom twosymbol examples):This symbol might be used in combinationwith a chemical symbol. In this case itcomplies with the requirement set by theDirective for the chemical involved.NOTE1. Slide the cover in the direction indicated by the arrowand remove it.2. Install two AAA alkaline batteries. Make sure thebatteries point in the direction marked in the batterycompartment.3. Use a thin object such as the tip of a pen to press theACL button.ACL buttonCAUTIONPb