Panasonic CS-RE9NKR Service Manual

Also see for CS-RE12NKR: Operating instructions

391. After front grille is taking off, remove the cover of control board and holder, and then the Main PCB can be seen.3. Drag out the supporting hook to the right side and pull up a bit the main PCB. Then release the lead wireconnecting to CN-FM, CN-STM3, earth wire (Yellow/Green) on main PCB, and take out the sensor from theholder on evaporator. Release the CN1 connector on indicator PCB. Pull out the whole electronic controller. Besure to avoid cracking of the supporting hook.4. Remove the control board completeLoose the screws of control board complete, then the whole control board can be pulled out.Removal Procedure for Main Electronic ControllerFront grilleMain PCBControl board coverHolderSupportingHookIndicator & receiverCN-FM: Fan motor connectorAuto OFF/ONswitch CN-STM3: Air swing motor connectorCN-TH: Sensor connectorCN1: Indicator connector