Panasonic CS-V9BKPG Service Manual

Contents

Panasonic CS-V9BKPG Service Manual Manual pdf 60 page image

1. The Electronic Controller, a Signal Receiver and anIndicator (Fig. 3) can be seen by the below steps:• Remove the 2 caps and 2 screws at the bottom of theFront Grille. (Fig. 1)• Remove the Front Grille by releasing the 2 hooks at thetop of the Front Grille. (Fig. 1)• Remove the Control Board Cover by releasing the 2tabs at left, 1 tab on top and 1 tab at right side of theControl Board Cover. (Fig. 2)2. To remove the Electronic Controller:• Release the Particular Piece. (Fig. 3)• Release the hook that hold the Electronic Controller.(Fig. 3)• Remove the Control Board by:-− Releasing CN-REC/DISP connectors. (Fig. 4)− Releasing CN-FM connectors. (Fig. 4)− Releasing CN-STM connector. (Fig. 4)− Removing the Earth Wire screw. (Fig. 4)− Releasing the Intake Air Sensor. (Fig. 4)− Releasing the Piping Sensor. (Fig. 4)Fig. 1Fig. 2Fig. 3Fig. 412 Servicing InformationCaution:• Pb free solder has a higher melting point than standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher. Please usea high temperature soldering iron. In case of the soldering iron with temperature control, please set it to 700 ± 20°F (370 ± 10°C).• Pb free solder will tend to splash when heated too high (about 1100° F/600°C).12.1. Indoor Electronic Controllers Removal Procedures12.2. Indoor Fan Motor and Cross Flow Fan Removal Procedures60CS-V9BK PG CU-2 V14B KP5G / CS-V9BKP G CU-2 V18B KP5G / CS-V9BKP G CU-3 V20B KP5G / CS-V7BKP G CU-2 V19B KP5G / CS-V12B KPG