Panasonic CS-YE9QKE Service Manual

Also see for CS-UE12QKE: Operating instructions Operating instructions

Contents

Panasonic CS-YE9QKE Service Manual Manual pdf 38 page image

3811.2.3 Indoor Unit Installation● Do not turn over the unit without it’s shock absorber during pull out the piping.It may cause intake grille damage.● Use shock absorber during pull out the piping to protect the intake grille from damage.P US H PUS HPipingIntake grillepulloutthepipingP USH P USHPipingShock absorberpulloutthepiping11.2.3.1 For the right rear pipingStep-1 Pull out the Indoor pipingStep-2 Install the Indoor UnitStep-3 Secure the Indoor UnitStep-4 Insert the power supply cord and connection cable• Insert the cables from bottom of the unit throughthe control board hole until terminal board area.11.2.3.2 For the right and right bottompipingStep-1 Pull out the Indoor pipingStep-2 Install the Indoor UnitStep-3 Insert the power supply cord and connection cableStep-4 Secure the Indoor Unit• Insert the cables from bottom of the unit throughthe control board hole until terminal board area.11.2.3.3 For the embedded pipingStep-1 Replace the drain hoseStep-2 Bend the embedded pipingStep-3 Pull the connection cable into Indoor UnitStep-4 Cut and flare the embedded piping• The power supply cord and indoor unit andoutdoor unit connection cable can be connectedwithout removing the front grille.• Use a spring bender or equivalent to bend thepiping so that the piping is not crushed.• When determining the dimensions of the piping,slide the unit all the way to the left on the installationplate.• Refer to the section “Cutting and flaring the piping”.Step-5 Install the Indoor UnitStep-6 Connect the piping• Please refer to “Connecting the piping” column inoutdoor unit section. (Below steps are done afterconnecting the outdoor piping and gas-leakageconfirmation.)Step-7 Insulate and finish the pipingStep-8 Secure the Indoor Unit• Please refer to “Insulation of piping connection”column as mentioned in indoor/outdoor unitinstallation.Right Rear pipingCover for thebottom pipingCover for thebottom pipingTape it withpiping in a positionas mentioned inFig. below.Cover forthe rightpipingPipingDrainhoseCoverfor theleftpipingCover for pipingHow to keep the coverIn case of the cover is cut, keep the cover at the rear ofchassis as shown in the illustration for futurereinstallation.(Left, right and 2 bottom covers for piping.)Install the indoor unitDrain hoseSleeve forpiping holeIndoor unitHooks atinstallationplatePipingHook the indoor unit onto the upper portion ofinstallation plate. (Engage the indoor unit withthe upper edge of the installation plate).Ensure the hooks are properly seated on theinstallation plate by moving it in left and right.Secure the Indoor UnitInstallationplateUnit’shookmarkingTo take out the unit, push the marking atthe bottom unit, and pull it slightly towards youto disengage the hooks from the unit.Right and Right Bottom pipingCover for thebottom pipingCover forthe rightpipingPipingDrain hoseCover forthe leftpipingTape it withpiping in a positionas mentioned inFig. below.Guidesurface Connection cableAbout70 – 80 mmConnection cableGas sidepipingLiquid sidepipingDrain hoseInsert the connection cable1. Press the lower left and right side of the unitagainst the installation plate until hooksengages with their slot (sound click).(This can be used for left rear piping and left bottompiping also.)