Panasonic CX-DH801N Operating Instructions Manual

Also see for CX-DH801N: Brochure & specs

Contents

Panasonic CX-DH801N Operating Instructions Manual Manual pdf 24 page image

47CX-DH801N46 English46 CX-DH801N45 EnglishInstallationHABCVHABCVInstallation LocationAvoid installing the unit in the following locations.¡In areas hit by direct sunlight, hot air from the heater, or any other high-temperature location.¡In an area where you cannot firmly secure the unit, or in high-vibration areas.¡In areas with high humidity or high dirt and dust levels.Use a screwdriver to set the angle-adjusting screw to the position “V” or “H”, depend-ing on the mounting angle selected.This unit can be set in the five directions: horizontal, vertical, and the positions A(22.5°), B (45°), and C (67.5°). Mount the unit by referring to the figures below.Select the mounting angleDefault: HAdjust the angle with a screw driverHABCVHCBAVHABCVHCBAVHABCVHCBAVHABCV VHCBA HABCVHCBAVA (22.5°)A (22.5°) B (45°)B (45°) C (67.5°)H (0°) V (90°)(L) (R) (L) (R) (L) (R) (L) (R) (L) (R)Cautions:¡Set the angle-adjusting screw to the same angle as the unit is installed.¡Set the holes to the same positions for both left and right.Installation (Continued)Please check that all installation hardware listed below are included.QtyDiagramItemNo.❑ Installation Hardware (For wiring)uio!0!1!2111 set121POWERExtension Cord (5 m)(BRAKE / VIDEO-CONT / ACC / BATT/ DIN / RCA / GND)YAJ024C107ZAClip ConnectorYEAT034C012Remote Control Sensor ( cable length 3 m )YEFX9991540Note:¡The number in parenthesis underneath each accessory part name is the part number for maintenance and service.¡Accessories and their parts numbers are subject to modification without prior notice due to improvements.Remote Control Sensor Extension Cord (3 m)YAJ074C024ZACord Clamp(for Remote Control Sensor)YEFX007570Double-Faced Adhesive Tape(for Remote Control Sensor)YFX994C124ZAQtyDiagramItemNo.❑ Installation Hardware (For Mounting)qwerty424112Hex. Bolt with Double Washers (4 mm x 8 mm)YJT034C707ZABase BracketYFG014C920ZCHex. Nut (5 mm )YJN014C703ZAMounting Bracket (L)YFX214C387ZAMounting Bracket (R)YFX214C386ZADouble-Faced Adhesive TapeYFX9994C725ZANote: For installation, use the screws shorter than 5 mm if you should use the screw other than aboveHex. Bolt with Double Washers q.Horizontal:Vertical:Installation Angle Selecting a mounting angle(Normal) (Up-side down)HABCV(Normal) (Up-side down) HABCVTypical horizontal installationTypical vertical installationSet the screw to thesame positions forboth left and right.Set the screw to thesame positions forboth left and right.Do not tilt in thisdirection.Limit to less than10 degrees.Limit to less than 10 degrees.Limit to lessthan 10degrees.(90˚)(0˚)