Panasonic CY-VHD9500U Operating Instructions Manual

Also see for CY-VHD9500U: Operating instructions Instalation guide Installation instructions

Contents

Panasonic CY-VHD9500U Operating Instructions Manual Manual pdf 23 page image

50 CY-VHD9500U CY-VHD9500U 5112Remote Control Unit PreparationBattery Installation1 Remove the battery holder.With the remote control unit placed on a flatsurface:1 Stick your thumbnail into the groove, andpush the holder in the direction of the arrow,and at the same time2 Pull it out in the direction of the arrow usinga tough pointed object.Battery Notes≥ Battery type: Panasonic lithium battery(CR2025/1F) (supplied)≥ Battery life: Approximately 6 months undernormal use (at room temperature)Back side23Lithium battery (supplied)Battery holderCaution:≥ Improper use of the battery may causeoverheating, an explosion or ignition, resultingin injury or a fi re. Battery leakage may damagethe product.≥ Do not expose the remote control unit to directsunlight.≥ Do not recharge, disassemble, deform or heatthe battery.≥ Do not put the battery in fire or water.≥ Immediately replace used up battery.≥ Obey local ordinances when disposing of thebattery.Monitor Position AdjustmentOpen the Display Unit1 Push the display release button (PUSH OPEN)until the display is unlocked.(Press the button with one hand while holdingthe display with the other.)2 Open the display unit by both hands until acomfortable viewing angle is reached.Maximum120eClose the Display UnitMove the display unit by both hands until thedisplay release button is locked.Note:≥ Always use both hands to open or close thedisplay unit.≥ Always check that the display release button islocked after closing the display unit.≥ If the display unit cannot be locked, be sure toconsult your dealer and remedy the situation.Display Unit Lateral AngleAdjustmentYou can swivel it to the left and right, 30˚ each way.Hold the display unit by the non-slip part in theupper half of it and adjust its lateral angle.30e30eENGLISH7ENGLISH8Note:≥ To ensure that the remote control unit is notlost or misplaced, use the accessory magic tape(“Velcro”) to secure it at a safe place.(PUSH OPEN)2 Install the battery on the battery holder.Set a new battery properly with its (+) side facingup as shown in the figure.3 Insert the battery holder back into its originalposition.≥ Remove all oil, water, surfaces where the magictapes are to be attached.magic tape (“Velcro”)(supplied)Tough pointed object