2. Names and OperationsEN-3EN1. Operation DisplayDisplays the operation status. (The fi gureshows all the statuses.)• The auto-fl ap display may be different,depending on the installed unit. (See PageEN-11)2. Start/Stop buttonPressing this button once starts and pressingagain stops the operation.3. Fan speed button4. Swing/Wind Direction button5. Timer setting buttonUse for operating with a timer.6. Reset buttonUse this button after changing the batteries.7. CoverPress at the top center and then slide down.8. Transmitter9. Remote control sensorDetects the temperature at the remotecontroller when detection has been switchedto the remote control by the sensor button.10. Temperature setting buttonsraises the temperature setting 1 °C ata time.lowers the temperature setting 1 °C ata time.11. Filter buttonCZ-RWSC2Press to turn off the fi lter lamp on thereceiver.12. Mode Select buttonPress to switch the operation mode.13. Ventilation buttonUse this when connected to an aftermarketfan. Pressing this button starts and stops thefan. When the air conditioner is started orstopped, the fan starts or stops at the sametime. ( appears on the display of theremote control when the fan is operating.)14. Address button15. Sensor buttonUse this when switching to detect thetemperature at the remote control. Atshipping the default setting is set to detectthe temperature at the unit. At this time isshown on the display.16. Clock buttonUse this when setting the clock.REMOTE CONTROL One remote control can control a group of up to eight indoor units.(See Page EN-12)From this page on the names of remote controlbuttons will be abbreviated as the illustration ofthe “button”.E.g.: Start/Stop button Æ