151VQT3A55Playback/EditingNote• The number of prints can be set from 0 to 999.• With a printer supporting PictBridge, the date print settings of the printer may take precedenceso check if this is the case.• It may not be possible to use the print settings with other equipment. In this case, cancel all thesettings, and reset the settings.• If the file is not based on the DCF standard, the print setting cannot be set.• [PRINT SET] cannot be set for motion pictures and pictures that were taken with the[QUALITY] set to [ ].You can set protection for pictures you do not want to be deleted by mistake.• For details about the icon display during Burst Picture Group playback, refer to P138.1 Select [PROTECT] on the [PLAYBACK] Mode menu. (P54)2 Press 3/4 to select the item and then press [MENU/SET].• When [SINGLE IN BURST GROUP] or[MULTI IN BURST GROUP] is selected, press 3/4/2/1 toselect burst picture group, and press [MENU/SET] to proceed tostep 3.• When [CANCEL] is selected, see “ Cancelling all the [PROTECT]settings ” .∫ Cancelling all the [PROTECT] settings1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].2 Press 3 to select [YES] and then press [MENU/SET].• If you press [MENU/SET] while cancelling protection, the cancelling will stop halfway.Note• The protect setting may not be effective on other equipment.• Even if you protect pictures on a card, they will be deleted if the card is formatted.• Even if you do not protect pictures on a card, they cannot be deleted when the card’sWrite-Protect switch is set to [LOCK].P [PROTECT]3 Select the picture, and then press[MENU/SET].When [MULTI] has been selected• Repeat these steps for each picture.• The settings are cancelled when[MENU/SET] is pressed again.• Press [‚] to return to the menu screen.[SINGLE] [MULTI]Press 2/1 to selectthe picture.Press 3/4/2/1 toselect the pictures.
