OthersUsing the AC adaptor (optional) and DC coupler(optional) instead of the batteryVQT4T08- 271 -By using the AC adaptor (optional) and DC coupler (optional), you can record and playback without worrying about the remaining battery charge.The optional DC coupler can only be used with the designated Panasonic AC adaptor.DC IN socketDC couplerDC couplercoverConfirm the directionof the connector andinsert it straight into thesocket.AC adaptorInsert DC coupler instead ofbatteryOpen DC coupler cover• If difficult to open, with the card/battery door open, press the DCcoupler cover from the inside toopen it.Close the door and slide therelease lever to the [LOCK]positionPlug AC adaptor into poweroutletConnect AC adaptor to DCIN socket of DC coupler● Always use a genuine Panasonic AC adaptor (optional).● Use the AC adaptor and DC coupler specifically for this camera. Using other adaptorsor couplers could cause camera failure.● It may not be possible to install camera on a tripod or unipod when the DC coupler isconnected, depending on the type of tripod or unipod.● The camera cannot be stood up when the AC adaptor is connected. If you are leavingthe camera on a surface as you work, it is recommended to set it on a soft cloth.● When the AC adaptor is connected, always remove the AC adaptor when opening thecard/battery door.● Remove the AC adaptor and DC coupler when not in use and close the DC couplercover.● Also read the AC adaptor and DC coupler operating instructions.
