Panasonic DMP-B15 Operating Instructions Manual

Also see for DMP-B15 - Portable Blu-ray Player: Specifications Operating instructions Operating instructions Operating instructions

Panasonic DMP-B15 Operating Instructions Manual Manual pdf 40 page image

RQT9334(ENG)40R eferenceIndicators and screen messagesIndicatorsScreen messagesThe [Í] indicator flashesrapidly.≥The unit has malfunctioned. Consult your dealer.The [Í] indicator flashesslowly.≥“Monitor” on LCD Menu is “Off” (no image). Turn the unit off when no image is being played.The [CHARGE] indicatorflashes rapidly.≥There is a problem with the battery pack. Turn the unit on and check the message on theLCD. (D below, 41)The [CHARGE] indicatorflashes slowly.≥Battery pack charge is low. The unit will turn off automatically after a few minutes.Cannot read. Please check thedisc.≥Clean the disc. (> 5)≥You inserted a disc that has not been finalized. (> 6)ERROR U580 ≥A problem has occurred with the battery pack. Consult your dealer.ERROR U581 ≥The battery pack has been recharging but has failed to recharge for some reason. Rechargeagain.ERROR U582 ≥You are recharging in a location that is too hot or too cold. Recharge at normal temperature[i5 to i35 oC (i41 to i95 oF)].PLEASE WAIT ≥The unit is starting up. Wait until the display disappears.F99 ≥The unit is not operating correctly. Press [POWER Í/I] on the unit for 3 seconds or longerand turn off the unit. Then, turn on the unit again by pressing [POWER Í/I].U72U73≥There was a problem when connecting the HDMI.j Connected device is not compatible with HDMI.j Use a cable with an HDMI logo.j The HDMI cable is damaged.U76 ≥BD-RE, BD-R, BD-Video or DVD Video with copyright protection cannot be played backsince the device connected to the HDMI terminal is not compatible with the copyrightprotection.U77 ≥Video cannot be output since the copyright protection information on the BD-RE, BD-R, BD-Video or DVD Video being played back is not valid.F ∑∑H ∑∑(∑∑ stands for a number.)≥A problem has occurred. (Numbers following the “F” or the “H” will be different depending onthe status of the unit) Turn off the unit once, and turn it back on. Alternatively, turn off theunit, disconnect the AC adaptor and the battery pack, and attach them back again.Authorization Error.This unit is not authorized toplay this title.≥[DivX]: You are trying to play the DivX VOD content that was purchased with a differentregistration code. You cannot play the content on this unit. (> 20)Cannot play. ≥You inserted an incompatible disc (Discs recorded in PAL video, etc.). (> 6)Cannot display on this unit. ≥You tried to play a non-compatible image. (> 38)≥Re-insert the SD card.No disc is inserted. ≥The disc may be upside down.Rental Expired. ≥[DivX]: The DivX VOD content has zero remaining plays. You cannot play it. (> 20)$ This operation is notavailable.≥Some operations are unsupported by the unit. For example;j [BD-V]: During playback, reverse slow-motion or reverse frame-by-frame is not possible.$ This operation is prohibitedby this disc.≥Depending on the disc, you may not be able to perform search or skip when film previewsand warning screens are being played back.Cannot connect.Please check the connection ofthe LAN cable.≥When a hub is used but its Link lamp does not light up, check the cable connection, LANterminal connection, cable itself (a crossover cable may have been used by mistake), etc.(> 28)IP address is not set. ≥The “IP Address” in “IP Address/DNS Settings” is “---. ---. ---. ---”. Set the “IP Address”,“Subnet Mask”, and “Default Gateway”. (Select the automatic address acquisition ifnecessary.) (> 29)Cannot obtain IP address usingDHCP.Please check the connection orrouter settings.≥If you use a hub, then check the connection between the hub and the router.j Use the UPLINK port of the hub to connect to a router. (> 28)j Check whether or not the hub’s Link lamp lights up. If it does not light up, then check thecable connection, LAN terminal connection, cable itself (a crossover cable may havebeen used by mistake), etc.≥If the above conditions are OK, then the router may not operate in DHCP mode. Check therouter settings and operation. You may reset the router to restore it to normal. (> 29)