Panasonic DMP-BD65 Operating Instructions Manual

Also see for DMP-BD45: Operating instructions Basic operating instructions Basic operating instructions

Panasonic DMP-BD65 Operating Instructions Manual Manual pdf 30 page image

30VQT2H94R eferenceR eferenceTroubleshooting guideBefore requesting service, please perform thefollowing steps.The following do not indicate a problem with this unit:≥ Regular disc rotating sounds.≥ Image disturbance during search.∫ Unit doesn’t respond to remote controlor front panel buttons.Press and hold [Í/I] on the main unit for 3 seconds.– If still unable to turn the unit off, disconnect the AC mainslead, wait 1 minute, then reconnect the AC mains lead.∫ Cannot eject disc.The unit may have a problem.1 While the unit is off, press and hold [OK], the yellowbutton and the blue button on the remote control at thesame time for more than 5 seconds.– “00 RET” is displayed on the unit’s display.2 Repeatedly press [1](right) on the remote control or [Í/I]on the unit until “06 FTO” is displayed on the unit'sdisplay.3 Press [OK] on the remote control or [< OPEN/CLOSE] onthe unit.To return to the factory preset.¾ Select “Yes” in “Default Settings” in the Setup menu. (> 29)To return all settings to the factory preset.¾ Reset the unit as follows:1 While the unit is off, press and hold [OK], the yellowbutton and the blue button on the remote control at thesame time for more than 5 seconds.– “00 RET” is displayed on the unit’s display.2 Repeatedly press [1](right) on the remote control or [Í/I]on the unit until “08 FIN” is displayed on the unit's display.3 Press and hold [OK] on the remote control or [< OPEN/CLOSE] on the unit for at least 3 seconds.Power of this unit is turned off when the inputfor the TV is switched.¾ This is a normal phenomenon when using VIERA Link(HDAVI Control 4 or later). For details please read theoperating instructions for the TV.The remote control doesn’t work properly.¾ The remote control and main unit are using differentcodes. If “SET 1”, “SET 2” or “SET 3” is displayed when abutton is pressed on the remote control, change the codeon the remote control. (> 29)¾ It may be necessary to set the manufacturer code or theremote control code again after changing the batteries forremote control. (> 14)The TV tuner mode is not displayed when theTV is switched on.¾ This phenomenon may occur, depending on the TVsetting, when “Quick Start” is set to “On”.– Depending on the TV, this phenomenon may be preventedby reconnecting the HDMI cable to a different HDMI inputterminal or by changing the HDMI auto connection setting.You have forgotten your ratings password.You want to cancel the ratings level.¾ The ratings level returns to the factory preset.1 While the unit is on, press and hold [OK], the yellowbutton and the blue button on the remote control at thesame time for more than 5 seconds.– “00 RET” is displayed on the unit’s display.2 Repeatedly press [1] (right) on the remote control or [Í/I] on the unit until “03 VL” is displayed on the unit'sdisplay.3 Press [OK] on the remote control or [< OPEN/CLOSE] onthe unit.Do you have the latest firmware installed?Firmware updates may be released to correct operatingirregularities that are discovered with certain movies.(> 14)4Make the following checks.If the problem remains unresolved, consultyour dealer for instructions.General operation