Panasonic DMR-E85HS Operating Instructions Manual

Also see for DIGA DMR-E85: Firmware instructions

Contents

43RQT7305 Convenient functionsChannel/Clock settings when TV Guide On Screen system is not usedRefer to the control reference on page 40.Preparation:If the television program list has already been downloaded, return the unit to the factory preset condition using the steps indicated below.When the unit is on and stopped1 Press and hold [X CH] and [W CH] on the main unit for about five seconds.The unit turns off.2 Press [Í DVD POWER] to turn the unit on.3 Complete the TV Guide On Screen system setup (until [ENTER] is pressed after the “Watch TV” message screen is displayed).[Note]You can set timer recording only manually after you set the unit with “Auto Channel Setting”.1 Press [SETUP].2 Press [3, 4] to select “Channel” andpress [1].3 Press [3, 4] to select “Auto ChannelSetting” and press [ENTER].4 Press [2, 1] to select “Yes” andpress [ENTER].5 Press [ENTER].Auto Channel Setting starts. This takes a few minutes.The unit then proceeds with Auto Clock Setting. The time isdisplayed when finished.≥DST, Daylight Saving Time, shows the summertime setting.≥TIME ZONE shows the time difference from Greenwichmeantime (GMT).EST (Eastern Standard Time) l GMT j5CST (Central Standard Time) l GMT j6MST (Mountain Standard Time) l GMT j7PST (Pacific Standard Time) l GMT j8AST (Alaska Standard Time) l GMT j9HST (Hawaii Standard Time) l GMT j10For other areas: xx hr≥If the Auto Clock Setting does not start automatically, select“Auto Clock Setting” from the “Set Up” tab.≥If the time was not set correctly, use manual clock setting(➡ page 11) or time zone adjust.6 Press [ENTER].≥The unit configures channels according to the AntennaSystem settings as follows.Adjust the time zone (j1 or i1) if it was not set correctly with autoclock setting.You cannot change this setting if you set the clock manually.1 Press [SETUP].2 Press [3, 4] to select “Set Up” andpress [1].3 Press [3, 4] to select “Time ZoneAdjust” and press [ENTER].4 Press [3, 4] to select “s1” or “r1”and press [ENTER].To exit the screenPress [SETUP].To return to the previous screenPress [RETURN].Auto channel/clock settingsSETUPDiscVideoAudioAuto Clock SettingAuto Clock Setting is complete.4/4/2002 12:15 AMDST............. ONTIME ZONE.... CSTChannelSet UpAntenna system Band ChannelTV VHF 2–13UHF 14–69CATVVHF 2–13CATV LOW BAND 95–99CATV MID/SUPER BAND 14–36CATV HYPER BAND 37–65ULTRA BAND 66–94100–125SPECIAL CATV CHANNEL 1Time Zone AdjustSETUPDiscVideoSet UpTime Zone Adjustj10i1Channel