19RQT8157You can configure the remote control TV operation buttons to turnthe television on/off, change the television input mode, select thetelevision channel and change the television volume.1 Point the remote control at the televisionWhile pressing [Í TV], enter thecode with the numbered buttons.Manufacturer and Code No.2 Test by turning on the television andchanging channels.≥Repeat the procedure until you find the code that allowscorrect operation.≥If your television brand is not listed or if the code listed foryour television does not allow control of your television, thisremote control is not compatible with your television.[Note]≥If your television brand has more than one code listed, select theone that allows correct operation.Change the remote control code on the main unit and the remotecontrol (the two must match) if you place other Panasonic productsclose together.Use “DVD 1”, the factory set code, under normal circumstances.1 While stoppedPress [FUNCTIONS].2 Press [3, 4] to select “To Others”and press [ENTER].3 Press [3, 4] to select “SETUP” andpress [ENTER].4 Press [3, 4] to select “Others” andpress [1].5 Press [3, 4] to select “RemoteControl” and press [ENTER].6 Press [3, 4] to select the code(“DVD 1”, “DVD 2” or “DVD 3”) andpress [ENTER].7 To change the code on the remote controlWhile pressing [ENTER], press andhold the numbered button ([1], [2] or[3]) for more than 2 seconds.8 Press [ENTER].∫ When the following indicator appears on theunit’s displayThe unit’s remotecontrol codeChange the code on the remote control to match the main unit’s(➡ step 7).[Note]Executing “Shipping Condition” in the SETUP menu returns themain unit code to “DVD 1”. Change the remote control code to 1(➡ step 7).To return to the previous screenPress [RETURN].To exit the screenPress [RETURN] several times.Television operatione.g., 01: [0] ➡ [1] 10: [1] ➡ [0]Brand CodePanasonic/National 01/02/03/04GOLDSTAR/LG 15/16HITACHI 08JVC 07MITSUBISHI 09/10NEC 13PHILIPS 12SAMSUNG 12/17/18SANYO 14/19SHARP 11SONY 05TOSHIBA 06When other Panasonic productsrespond to this remote controlSETUPTuningRemote ControlPress “±” and “ENTER” togetherfor more than 2 seconds on the remotecontrol.DiscPictureSTEP 3 Set up to match your television and remote control